0
How reset check engine light 2001 Accord in computer after replacing ox sensor?
Wiki User
∙ 17y ago
THE CHEAP WAY.... DISCONNECT THE BATTERY FOR A MINUTE OR SO. JOSE
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
Replaced fans radiator sensor rfw engine light still on?
If an engine light is still on after replacing a fan's radiator sensor in a RFW engine the coolant sensor should also be checked. If the coolant sensor is bad it will send an error code to the car's computer.
Where is the temp sensor at 91 Honda Accord?
The water temperature sensor on your 1991 Honda accord, is located on the front of the engine. The sensor is above the water thermostat housing.
Where is o2 sensor located on 89 Honda Accord lxi?
The Oxygen sensor of a 89 honda accord lxi fuel injection 2.0 valve engine is located in front of the engine on the manifold .
What would cause a speedometer to stop working on a 1996 Honda Accord?
there is a sensor in one of the drive shaft that finds the speed it could either be that or the engine computer is failing
Why is the engine light still on after replacing the crank sensor on a Mazda 626 1996?
Because after you change a sensor you have to hook a OBD I or II to your computer's wire harness to clear the code. Or you can turn the backwards and then forwards and sometimes that will reset it. Either way changing the sensor won't reset the check engine light...U have to clear it thur your computer.
How to Replacing oil pressure sensor 92 Honda Accord?
The oil pressure sensor on a 92 Honda Accord is replaced by disconnecting the wiring harness and unscrewing it using a wrench or socket set. The replacement sensor is then put into place and torqued back to specs.
Is there a Engine coolant sensor test for a carbureted 87 accord with a single sensor wire?
You can test the engine coolant sensor by using an ohmmeter. Attach the positive and negative probes to the terminals of the coolant sensor.
What does a crank shaft sensor do on a 1998 Honda accord?
A crank shaft position sensor on a 1998 Honda Accord reads whether or not a the engine is spinning correctly. If there is a discrepancy on how the crankshaft is spinning the sensor will relay it to the ECU.
How do you reset check engine light after replacing O2 sensor on 2004 pt cruiser?
Just unplug the negative terminal of the battery for about 10 minutes and that will reset the computer
Where is the control sensor located on a 1992 Honda accord?
they are located near the front engine
Does a 98 expedition Oxygen sensor need codes when replaced?
Just reset your computer after replacing the O2 sensor.
After replacing the sensor how does it take the car computer to reset?
Remove the negative power line to the battery. Wait a few seconds and replace. That will reset the check engine light. darksidesteve
