Pull off the dash center trim strip starting at the passenger door and work your way over to the steering column. It pulls straight out via clips. Disconnect any electrical connectors going to the dash trim. Use a 7mm socket to remove the 4 hex screws holding the EATC into the dash. Use a 10mm socket to remove the stamped hex nuts holding the vacuum line connector to the EATC. To install, reverse these directions.
You must remove the dash.
i have a 95 mercury grand marquis how do i remove the passtime device You should NOT unless you paid off the car. the dealership will then remove it.
Remove the tire and wheel from your 1996 Mercury Grand Marquis. Remove the ball joint retaining nuts. Pound the ball joint out with a hammer. Reverse the process to install your new ball joint.
It's in the tank.
Remove the spark plug wires from your 2002 Mercury Grand Marquis spark plugs. Remove the spark plugs by turning them to the left with a deep well 5/8 socket. Reverse the process to install the new spark plugs.
i'm asking the question
how to remove right turn signal relay on 1986 mercury grand marquis
read the instructions manual.
Mercury Grand Marquis was created in 1983.
Just remove the coil on top of the plug.
Unbolt it from the floor.
Begin by removing the wiring harness from your 1994 Mercury Grand Marquis power antenna. Remove the power antenna retaining nuts. The power antenna will come off.