How to Removing starter from 2005 Chevy Colorado?

Answer 1

1. Remove the throttle body.
2. Remove the battery box.
3. Remove the oil level indicator and tube.
4. Disconnect the brake booster hose (6) from the brake booster.
5. Disconnect the MAP sensor electrical connector (3).
6. Disconnect the MAP sensor wiring harness retainer (4) from the intake manifold (5).
7. Disconnect the PCV dirty air tube (2) from the camshaft cover.
8. Remove the generator.
9. Disconnect the engine wiring harness retainer (1) from the intake manifold (2).
10. Remove the 2 upper bolts securing the engine wiring harness bracket to the intake manifold.
11. Raise and support the vehicle only high enough to access the remaining components through the wheelhouse.
12. Remove the left front wheel.
13. Remove the left front wheelhouse liner.
    • The battery cable
    • The engine (4, 6)
    • The MAP sensor (5)
14. Disconnect the following wiring harness retainers from the engine wiring harness bracket:
15. Remove the remaining engine wiring harness bracket bolt. Remove the bracket from the engine compartment through the wheelhouse opening
16. Remove the intake manifold bolts.
17. Lower the vehicle.
18. Remove the intake manifold from the cylinder head.
19. Remove the seal from the intake manifold. Discard the seal.
20. Mask off the open ports to the cylinder head, in order to prevent foreign objects from entering the engine.
21. Clean and Inspect the intake manifold.