you have to take everything off...bearings, pins, bolts, EVERYTHING, starting from the center of it all. The last thing to take off is the rotor. Buy some bearing grease. You may as well repack your bearings. Also, check your cv boots. You may have to replace them too. If so, you may as well replace now while everything is off or your gonna have to do it all over again.
i also have a 96 slx . my trans. is bad to, so if u get yours fixed tell me how u did it. my e-mail is jonb4139@comcast.net
What should it cost to replace rear brakes, drums and rotors, '96 Volvo 850 GLT.
no
where is stater located on 1997 acura 3.5rl.
check fuse
The 91-04 NSX and 96-99 SLX have non-interference engines. All others (Integra, Legend, Vigor, MDX, CL, RL, TL) have interference engines. No data yet on the RSX and TSX, but I would think those models would most likely have interference engines.
Remove the tire and wheel. Remove the brake pads and hardware. The rotor will slide off. Reverse the process to install the new pads and rotor.
Warped brake rotors........
it probably has a leak...
To bleed the cooling system on a 96 Acura 3.5 L, cool the radiator and remove the radiator cap. Loosen the drain plug and drain.
2.27 galons is the coolant capacity for the acura RL 96-04.
The 1996 Acura Integra OBD 2 port is under passenger dash