Try Google searching a Home Depot video, that's what I'm going to try ..
RE : http://www.ehow.com/how_1000619_install-recessed-lighting.html look on the right hand side there's videos etc
From the attic
Try this site! I would also like to know how to install pot lights in the kitchen of a two story home..How do you get the wires past the studs in the ceiling to the other lights ? thanks...E First figure out where the joist spaces are. Get a stud finder and mark them out for better reference. Plan out where you want your pot lights to sit and cut out your holes. I use an appropriately sized hole saw. If you need to go through the joists you will need a drill and a drill bit that will make a hole big enough to get your wire through. If your pot lights are separated by multiple joists you will have to make holes in each joist space between them in the drywall to gain access. SAVE YOUR CUTOUTS! It will make patching the drywall a lot easier once you're finished.
Not enough information. Lights? Pumps?
check the fuse, if it is not blown, your tail lights may be missing ground, locate the ground wire on your tail light socket, then get a wire and a metal thumb tack, push the thumb tack thru the ground wire and splice the extra wire and wrap the bare wire around the thumb tack, turn your tail lights on and touch the bare metal of your van and see if it lights up, if it does lights up, just splice it and reconnect to the new ground source, hope this help you out :-)
The wire that lights up inside the globe is the filament.
There is no set distance from the wall. Sometimes a ceiling pot light is used as a wall washer to highlight a feature on the wall and will be places about 18" from the wall. Most times pot lights will be places in the center of the room to light the floor area.
Wire them in parallel. These are not Christmas tree lights. From the switch, all black wires together. All white neutrals together.
to wire the license plate lights you must have lights and wire them to the scooter.
how do i wire my brake lights on my Honda 1000
short in the wire or they are all on one wire
A thin strand of wire used to cut a clay pot off of the potting wheel after it is shaped. You pull it under the pot and it cuts it loose.
where does the yellow wire with a black stripe on it connect for dimmer lights,panel lights,and gear shift lights,for a 2000 Mitsubishi galant
Try this site! I would also like to know how to install pot lights in the kitchen of a two story home..How do you get the wires past the studs in the ceiling to the other lights ? thanks...E First figure out where the joist spaces are. Get a stud finder and mark them out for better reference. Plan out where you want your pot lights to sit and cut out your holes. I use an appropriately sized hole saw. If you need to go through the joists you will need a drill and a drill bit that will make a hole big enough to get your wire through. If your pot lights are separated by multiple joists you will have to make holes in each joist space between them in the drywall to gain access. SAVE YOUR CUTOUTS! It will make patching the drywall a lot easier once you're finished.
wire into the tail lights at the back of the car
how do i find a short in my head lights ,tail lights work but not my head lights
What kind of vehicle?
Positive wire touched negative wire on parking lights for 89 civic rt
The most common cause of taillights and â?? lights not working is a bad ground wire. The ground wire may be broken or the connection is corroded.