answersLogoWhite
Pontiac Grand Am
How To

How to change a 1996 grand am fan belt?

8910

Top Answer
User Avatar
Wiki User
2005-09-08 21:19:19
2005-09-08 21:19:19

Near the tensioner there should be a square hole that you can insert a 1/2" drive breaker bar/ large ratchet into. Crank it back and remove the belt. Watch the way it was routed.

1

Related Questions

User Avatar

There is no fan belt. The fan is electric.

User Avatar

right across the fan above the serpentine belt

User Avatar

how do you change a fan belt on a 406

User Avatar

use ratchet on square hole on tensioner to pull it back and loosen belt

User Avatar

How do you change a fan belt for a 2000 Toyota Avalon

User Avatar

There is no fan belt, they have electric fans.

User Avatar

how do I loosen fan belt to remaove alternator for replacement of alternator?

User Avatar

You will have to remove the motor mount which the fan belt runs through. The motor will have to be supported underneath with a big block of wood and a jack. A serpentine belt tool (rent for free from Canadian tire) will be needed to get the belt on.

User Avatar

peugeot 307 how to fit fan belt replacement

User Avatar

The 2000 Mazda Protege has electric fans, hence there is no fan belt to change.

User Avatar

how to change Renault megane timing belt

User Avatar

There is no fan belt it is all electric at least for 97 and later models.

User Avatar

The 1996 Pontiac Grand Prix cooling fan sensor is located on the front of the engine. The fan sensor can be found just above the thermostat.

User Avatar

there is no fan belt for that car. the fans are electric

User Avatar

the 1997 camaro doe's not have a fan belt it has a serpentine belt that you can change in about 5 min.

User Avatar

To change fan belt on a Rav 4, remove the bolt in front of the engine. Loosen the pulley and gently pull away the fan belt. Replace with new.?æ

User Avatar

Drain the radiator. Remove the pump belt, fan, and fan shroud. Unbolt the pump then remove it. Bolt the new pump on, and install the fan an shroud. Put the belt on and refill the radiator with fresh coolant.

User Avatar

you should have three belts total. Going from the fan towards the distributer the first belt should be the power steering, then the actual fan belt, then the third belt is the alternator / a/c belt, i hope this is helpful for you! So for the answer to your question, there is one fan belt, the second belt in from the fan!

User Avatar

remove your fan shroud then losen the tensioner and remove your belt.

User Avatar

replace fan belt on citron dispatch 02 hdi

User Avatar

take the fan belt off and put another one on...


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.