answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How to check the purge valve for a 2005 Chevy Cobalt?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do i replace the purge valve on a 1997 Chevy Monte Carlo?

How do i replace the purge valve on a 1999 Chevy Monte Carlo


Where is the canister purge valve located for a Chevy venture?

where is the canister purge valve located on a 03 chevy venture


Where is the purge valve located on 2006 Chevy Cobalt?

Probably inner fender. It purges gas fumes at start up so you can always follow the line from the tank to find it.


Where is the purge valve solenoid on your 2001 Chevy cavalier?

The purge valve solenoid on your 2001 Chevy Cavalier is located on the side of the engine. It is mounted on the block right below the intake manifold and can be distinguished because of the bracket attached to it.


What is the check engine code P0445 for a 1997 Chevy Malibu?

Trouble code P0445 means: Evaporative Emission System Purge Control Valve Circuit Shorted


93 Chevy silverado starts and runs fine until it warms up then it back fires and stalls when you give it gas?

check the egr vavle or the purge valve


Where is purge valve and low coolant sensor for 96 Chevy lumina van?

The purge valve sensor on the 96 Chevy Lunina van is on the driver's side of the engine about half way back from the bumper. The low coolant sensor is to the right of the front part of the engine, next to the PCV valve.


Where is the purge valve located in a Chevy Malibu?

The purge valve on the Malibu is located on top of the charcoal canister that is mounted on the side of, or in close relation to the fuel tank. Usually on the same side as the filler neck. This purge valve is not to be confused with the purge valve solenoid which is located on the intake manifold. If for some reason you can not find the purge valve/canister just locate the solenoid on the intake manifold (which will have an electrical plug and one vaccum line attached to it.) and trace the vaccum line under the car to the canister. As stated above...it is there that you will find the canister purge valve.


What is check engine code P1443?

This code indicates an incorrect Evaporative System Purge Control Valve flow. Can be caused by clogged, disconnected, or broken vacuum line between the EVAP Canister Purge Valve and intake manifold or bad Purge Valve itself.


The vacuum hose on a 1999 Chevy Malibu that comes from the PCV valve is not connected to anything where does it go?

it goes to the purge valve in the back of your motor.


Where is your Purge Vacuum Diagnostic Switch on a 1996 Chevy Tahoe?

its on top of passenger side valve cover


Will the check engine light go off after replacing the purge valve?

If the purge valve was causing the fault, the light may go out. If it was and it didn't you may need to re-set the system.