go to the SHO STORE site (as in Taurus sho)
and the TCCA (Taurus car club of America) site
Almost all Auto Parts stores and machine shops resurface rotors and brake drums.
A brake lathe is a metal lathe designed for truing the surfaces of automotive brake rotors which the brake pads bear upon.resurface rotors and drums
If the rotors have over heated you will get brake chatter. The pedal will shake when you apply the brakes. Usually the drums are a little tougher. The new rotors are very thin.
you might have to bring it to a brake lave to size up the rotors and brake drums.
Brake drums can not be cut. The shoes inside can be replaced.Only disc brakes(rotors) can cut.
pads
measure inside diameter of brake drum (where brake shoes touch drum) and measure outside diameter of brake rotors. usually if you look at wheel side of drums and rotors the size is stamped in millimeters on each
Either your drums or rotors are out of round.
rear brake drums or rotors are out of round.
asbestos are in the brake pads and shoes, metal in the rotors and drums, brake fluid in the lines.
Brake rotors and brake drums.
Brake vibration is usually caused by the brake rotors being warped. The rotors must be machined or replaced to correct the problem. if you can feel it in the steering then the drums are or rear rotor could be warped