answersLogoWhite

0


Best Answer

It should be the yellow wire that runs from the ign. harness from the steering wheelit will be about a 12 ga wirethis wire will be with about 5-7 other wires of the same gauge.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How to determine wires to cut at ignition switch for remote start need color for wire to starter motor and primary ignition?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How difficult is it to change out the starter in a 1994 Ford Escort?

Not that hard, it's located on the back side of the motor. Make sure it's the starter. You can test it with a remote starter. My car has the problem with the ignition, because it started when I hooked up the remote.


How does a remote auto starter work?

For a remote auto starter to work, a person must first press his/her keyless control. This sends a radio signal to the module located within the car. The module activates the ignition. After the ignition is activated, the car starts up without the person having to do it manually.


What tool is used to energize the starter motor with the ignition system disabled?

A remote starter switch that most mechanics have in their tool box or a simple jumper wire will work.


Why wont a 91 Chevy baretta not shut off when key is turned off?

Does it have a remote starter? Defective ignition switch?


I am trying to put a remote starter in my 2003 Rav4 and I can't find the coil ---- Where is it --- Also is the high votage coil starter the same as the high coil?

02 to 04 RAV's got individual computer controlled coils your remote starter has to conected to the ignition assembly in the steering cullum.


How do you disable the anti theft protection system in a 2005 Chevrolet Colorado?

Install a remote starter, this will disable the passcode security to the ignition.


What are the steps to installing a remote car starter?

To begin with, check the box or manual of the remote car starter to see if the product is compatible with your car. Use a soldering iron to connect wires following the manual. If there is more than one wire for ignition, accessory or the starter, use a relay to connect them.


Starter makes grinding noise after engine is warm but if the remote start is used there is no noise is this due to a relay through the ignition switch?

The starter should only be making noise if you attempt to start the car and the starter is going bad. It is possible that the remote starter is bypassing the mechanical starter. Starters are very easy to replace. Be sure to disconnect the car battery before doing so.


Can you bypass the security ignition on a 2005 Chevy Malibu Classic?

I did it on a 98 Malibu by buying a remote starter and having it installed at car toys.


How do you disable wipers when starting ford minivan with remote starter?

What does a remote starter have to do with the wipers? Just turn them off when stopping the car, and then when you use the remote starter, the next time, the wipers will not come on. If the wipers are not on then they will not work, no matter if you are using a remote starter or not.


Why would a 2000 F150 v6 engine try to start with no key in the ignition and the ignition in the off position?

Somebody with the remote is messing with you. I had a similar problem years ago and found a defective starter solenoid was the problem


How do you change the fuse for the remote starter on Ford F-250?

The key remote? or the actual starter its self like valet starter..