0
Put the bike on its side stand. Loosen and remove the oil fil plug on the right hand top side of the crankcase. Put a funnel into the hole. Put a large pan or container under the crankcase. Loosen and remove the oil drain plug from the bottom of the crankcase. The old oil will run out. Then, put the oil drain plug back in and tighten it. Finally, pout the correct amount of JASO MA or MA2 certified oil into the crankcase. If you want to change the oil filter then do after you have drained all oil from the engine and before you fill up with new oil.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
How do you drain excess oil in Honda Accord?
Drain plug on bottom of oil pan.
What is the torque of the oil drain plug on a 1990 Honda Accord?
The correct tightening torque for a 1990 Honda Accord oil drain plug is 29 foot pounds. This same torque applies to all Honda oil drain plugs.
What is the torque spec on the oil drain plug for a 2006 Honda Odyssey LX?
2006 honda odyssey engine oil drain plug torque
Where is the oil drain plug on a 1981 GL1100 Honda goldwing?
The oil drain plug is on the front of the motor below the oil filter.
Where is the oil drain plug on a 2001 Honda Odyssey?
The oil drain plug is located on the bottom of the engine near the oil filter.
Where is the oil drain plug on a 2005 honda?
Bottom of the engine on the oil pan.
Where is the oil pan drain in a 1999 Honda accord?
It is located on the oil pan.
How do you drain engine block on 2007 Honda accord?
Remove the oil pan drain plug to drain the oil. Remove the lower radiator hose to drain the coolant.
How do you change motor oil on Honda xrm 125?
In order to change the motor oil on a Honda XRM 125 you need to lift the bike on a motorcycle rack. You then need to unscrew the drain plug, let the oil drain out, put the drain plug back in, change the oil and put new oil in.
Where is oil drain plug on 2004 Honda accord?
Bottom of the engine on the oil pan.
How do you change the oil in a 1990 Honda accord?
Raise the front of the Honda. With Jack and jack stands or ramps. Place your oil bucket/catcher under the oil pan. Then remove the drain plug on the bottom of the oil pan. Let the oil drain out. Then replace the drain plug. Then remove the oil filter and let drain into the oil bucket/catcher. Install a new oil filter and new oil. Lower the Honda back down. That's it. Save yourself $20 and have better products in your car.
Where is the drain bolt 2000 Honda Accord 4 cylinder?
The oil drain plug is located on the bottom of the engine screwed into the oil pan.
