0
What else can I help you with?
What does the terminology - radial feed - mean in relationship to transformers?
This terminology usually refers to pad mounted transformers. A "radial feed " transformer is a transformer that has one bushing for the high voltage cable line. The high voltage cable terminates into the transformer through the transformer's bushing. There is no second bushing for the high voltage cable to continue further down the line. This type of transformer is usually on the end of a loop feed circuit. This is different from a "loop feed" transformer whose incoming cables are terminated at the primary bushings. On this type of transformer there is a second bushing which connects to the outgoing primary voltage cables that allows the primary to feed another transformer. Each pad mount transformer's secondary feed usually supplies enough power to connect up to four homes.
What can a transformer not do?
Wash the car, feed the cat, turn lead in to gold... the list goes on and on.
Can a 1500KVA transformer feed a 1600A 480V service?
No, a 1500KVA transformer is not large enough to handle a 1600A load at 480V. The transformer should have a higher kVA rating to support the current demand of 1600A. A transformer with a minimum capacity of 1920KVA would be needed for this application.
What is the difference between yagi antenna and dipole antenna?
I don't think it has. Bandwidth depends on the diameter to length ratio of the antenna. The greater the diameter of the elements the wider the bandwidth. The inductance goes down and the capacitance goes up, giving the antenna a lower Q. the folded dipole has a greater effective diameter (at least double for the same materials). You can increase a normal dipole's bandwidth by increasing the diameter, hence the old time birdcage aerials.
What is a balance wheel on the sewing machine?
raise the needle feed or remove mistakes neellushah
What is a signal pulse transformer?
usually a small transformer ferrite rather than iron core for short pulses it is more for isolation than anything else trigger for scr or triac the previous question for a power pulse transformer these are in cars ignition transformers the newer cars generally have one on each cylinder the computer may feed may feed a signal pulse through the small transformer to isolate the computer from the big one. to an scr to discharge a capacitor thru the ignition transformer (cars use the terms condenser and coil)
Why was before used the 300 ohm transmission line?
The impedance of a centre fed dipole at resonance is about 73 ohms. The feed impedance of a folded dipole is four times that, 292 ohms. The feedpoint is of course balanced in both cases, thus 300 ohm balanced line is an excellent match for the folded dipole active element of a commercial TV antenna.
Can you use 20 kva transformer in a home?
Yes you could use a 20 kva transformer in a home. Stymied as to why it would be done though. You would need at least a 100 amp service to the home to energize the transformer. Primary side of the transformer would draw 83 amps at 240 volts. If the question was to supply the home, again yes. It would be 100 amp service equipment that the transformer would feed into.
What length of dipole in relation to its wavelength in meters or khz?
There are several kinds of dipole; the most common is the half-wave dipole. Its total length is fairly close to half the wavelength of the design frequency. The length needs to be adjusted slightly to compensate for the thickness of the elements and for end-effects. If the length is wrong by ten or twenty percent it will alter the feed impedance, but have little effect on the gain.
What does a feed pump do in pasteurization of milk?
The feed pump promote the flow of raw milk from balance tank to plate heat exchanger.
What are the lower parts of the sewing machine?
the presser foot the balance and the feed fog
What is a loop feed transformer?
A loop feed transformer is an electrical device used in power systems to facilitate the connection of multiple power lines, enhancing reliability and efficiency. It allows for the distribution of electricity from two or more sources, enabling supply continuity even if one source fails. This type of transformer is typically employed in distribution networks to improve load balancing and reduce losses. Its design aids in maintaining voltage stability across the connected circuits.
