The drive shaft does not leak. It is either the pinion seal or the trans. seal. Either one, the drive shaft has to be removed. The rear seal should be done at a garage, but you could do the front.
on the tail shaft of the transmission
A malfunction has been detected
Yes
Yes.
For a 2001 Ford Crown Victoria : It weighs ( less than 2 tons )
yes it does you don't need to be in 2nd gear anyways in a crown Victoria yes it does you don't need to be in 2nd gear anyways in a crown Victoria yes it does you don't need to be in 2nd gear anyways in a crown Victoria
Yes.
There is one fusebox in the engine compartment right behind the battery. The other fusebox in under the dash to the left of steering wheel shaft.
Bank 2 is the drivers side of the engine in your Crown Victoria
It should be a direct swap.
According to the 2001 Ford Crown Victoria Owner Guide : ( 19.0 U.S. gallons )
According to the 2001 Ford Crown Victoria Owner Guide : ( 19.0 U.S. gallons )