Auto Parts and Repairs
How To

How to make the airbag light go out after replacing air bags and module in a 97 Buick Rivera?

818283

Top Answer
User Avatar
Wiki User
2009-09-22 23:57:13
2009-09-22 23:57:13
Answer

You probably have to clear the computer error codes, this is generally what fires indicator lights. I don't know specifically about your car, but usually that is the case. This requires a code reader, plug it into the port (under the dash in most Fords - don't know about GMs) and let the reader cycle through 4 displays of the error codes. This will clear the computer and should make your light go off. If you don't have a code reader, I hear that AutoZone and some other parts stores will do this for you for free.

If your car has been in a collision, and you replaced the described parts then you have another problem. It is very easy to scan the system and get the codes. Most likely one of the crash sensors not correctly installed. Or could be they replaced the module with a used unit. NOTE: once a car has been crashed with airbag deployment, the module is no good. Must have either a new one, or used one from a car that has not been crashed. Also seat belt sensor, or burned out bulb for pass side air bag-specially in Fords.

1
馃檹
0
馃え
0
馃槷
0
馃槀
0

Related Questions

User Avatar

Where remote module in a 98 buick regal

User Avatar

My 97 Buick defogger module is in the rear leftinside panel.

User Avatar

Just like replacing the windshield. Really not a job for a do it yourselfer unless you have the experience and the tools. Then I guess your not a D-I-Y'er.

User Avatar

Where is the theft deterrent module on 1995 Buick Regal

User Avatar

Where is the fuses for the brakes lights Buick Rivera 1970

User Avatar

Whats the procedure for replacing a 2002 Buick Lesabre front strut.?

User Avatar

what is the wiring position for the ignition module on a 1990 Buick Park Avenue?

User Avatar

You can find the 2001 Buick Century Oddie control module on the passenger side firewall. The body control module will be near the bottom of the firewall.

User Avatar

if it is the factory alarm the module is behind the glove box, it is grey and has one wire terminal. i unplugged mine today and the alarm became disabled, one catch, your remote locking and entry will be disabled as well. if you are having alarm troubles try replacing the module and reprogramming the remote instead of disabling the alarm. the module is the same as a Bonneville module and can be purchased for peanuts at a wrecking yard. another problem is the mall module , its next to the alarm module and has two terminals, Buick has a recall on this module. good luck!

User Avatar

Follow the wires from the blower motor back toward the firewall. they attach to this module which is actually inside the vent. two screws and you can pull it out. easier if the blower is taken off first.

User Avatar

instructions for replacing air filter on 1989 Buick Skylark 4 cylinder

User Avatar

A person can reset the airbag light on 1997 Buick Regal by checking the wires and making sure they are all plugged in. Then by clearing the codes causing the light with an OBD scanner.

User Avatar

The easiest way to bypass the antitheft module in your 1997 Buick Skylark is to remove the fuse. The location of the antitheft module fuse is listed on the inside cover of the fuse box.

User Avatar

where is the engine controle module located in a 1995 buick lesabre

User Avatar

路 Rabbit (VW) 路 Range Rover (Land Rover) 路 Regal (Buick) 路 Reliant (Plymouth) 路 Renault 路 Rendezvous (Buick) 路 Rivera (Buick) 路 Roadmaster (Buick) 路 Rolls Royce

User Avatar

路 Rabbit (VW) 路 Range Rover (Land Rover) 路 Regal (Buick) 路 Reliant (Plymouth) 路 Renault 路 Rendezvous (Buick) 路 Rivera (Buick) 路 Roadmaster (Buick) 路 Rolls Royce

User Avatar

Instructions for replacing radiator on 2000 Buick Lesabre custom

User Avatar

No it does not out of all the97 Buick's I've seen none of them have it

User Avatar

路 Rabbit (VW) 路 Range Rover (Land Rover) 路 Regal (Buick) 路 Reliant (Plymouth) 路 Renault 路 Rendezvous (Buick) 路 Rivera (Buick) 路 Roadmaster (Buick) 路 Rolls Royce

User Avatar

what does the body control model do for a 95 buick real 3.8 litter

User Avatar

On my 91 its on the top of the rad support facing towards the front of the car, sort of hangs down and is on the drivers side of the car, that and the airbag module are the only things mounted on the rad support.

User Avatar

If you open the hood there should be a black plastic box to the right. Computer is in there. List car symptoms before replacing parts.

User Avatar

Where can I locate the "Lamp Control Module" on a 1994 Buick Park Avenue


Copyright 漏 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.