0
Remove the tire and wheel from your 1995 Chevy S 10 pickup truck. Remove the ball joint retaining nut. Pound the ball joint out with a hammer.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
Where is the turn signal flasher unit located on a 1995 Chevy Corsica?
Remove the lower dash panel in the drivers side it will be in the right of the steering coluum. == ==
How do you replace the CV joints on a 1995 Ford Taurus?
The CV joints on a 1995 Ford Taurus can be replaced by removing the front tires, and the nuts on the lower ball joint. Next, the lower ball joint will need to be removed and the CV joint can be removed.
How do you remove a spare tire 1995 Chevy astro van if the dutch door wont open?
You can access the mechanism to lower the spare tire from under the van.
How do you replace the lower ball joint on a 1995 Eagle Talon?
it has to be pressed out and back in
How do you remove and install ball joints in a Dodge Neon 1995?
Remove the tire and wheel. Remove the ball joint nut. Pound the ball joint out with a hammer or mallet. Reverse the process to install the new ball joint.
How do you remove a front brake rotor off a 1995 Chevy c1500?
Remove the tire and wheel from your 1995 Chevy. Remove the brake assembly. Tap on the brake rotor with a mallet or hammer. The brake rotor will slide off.
How to remove cylinder heads on a 1995 Chevy 350?
need year of vehicle first.1995
How do you remove brake drum on 1995 Chevy truck?
you get a towel and clean
How do you remove a universal joint in a 1995 crown vic?
It will be best to take it to a service shop.
How do you remove the headrest in a 1995 Chevrolet Corsica?
removal of 95 chevy corsica
Where can you get a picture of where lower raditor hose goes on 1995 Chevy lumina?
You can get that picture from google.com.
How do you remove the lower ball joints on a 1995 Oldsmobile ciera?
remove tires, remove both caliper bridge bolts, put caliper on upper control arm, remove rotor, take out lower ball joint bolt, using pry bar or pipe separate lower ball joint, if not lose already use pickle fork or a bar to put pressure and separate, move steering knuckle away from lower ball joint, use air hammer or equiv. and push rivets out of ball joint. once all three rivets are pressed out ball joint will fall out and re install. install ball joint, some come with bolts and nuts. factory control arm will only come with new riveted ball joint. put bolts and nuts on new ball joint, tighten install zerx fitting, re-attach steering kuckle to ball joint by pushing down on the lower control arm and then forward on the knuckle. to align ball joint with hole on knuckle. re-install new ball joint bolt. once tight grease zerx fitting. re install rotor, caliper ect.
