0
Take out the distributor.Take off the cap. Take off the rotor. Undo the bolt holding the bob weights. Remove the 2 screws holding the vacumatic advance unit on the outside and manouvre off the advance mechanism inside. Remove the 2 screws holding the bottom assembly. Mark position and remove. Now the module... You will see a small coil surrounding the center spindle,it's attached to the module which is held by 2 screws and 2 wires attached (take care to replace the wires in the same order). Remove the screws and lift out the coil/module. The coil is attached to the module by 2 slide-in contacts. Pull the coil off the module and put it on the replacement module. Be sure to put the heat sink white paste that comes with the new module. Re-assemble.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Where is the dura spark ignition module located on a 1991 Ford probe?
The 1991 Ford Probe spark ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
How do you replace ignition module on 1991 ford f-150?
Look on the side of your distributor. It takes a special wrench to remove it if it is there.
Where is the ignition module on a 1991 Oldsmobile regency?
The Ignition Control Module is on the top left hand side of the engine under the Ignition Coils.
Wiring order for a 1991 Pontiac SunBird ignition module?
what is the color order of the wires to a Pontiac Sunbird ignition module
How do you change the ignition in a 1991 Honda accord?
If you are having the same issues (starting problems-no spark) that I had in my 1991 accord, I found out that there appearantly was a recall on the distributor. Do not try to replace pieces and parts of the ignition system. (ie. coil, ignition control module, etc.) Replace the entire distributor. It will save you hours of frustration.
Why won't my 1991 Mercury Capri won't fire replaced plugs and wires?
Assuming it is getting fuel and you have no spark, replace the ignition module.
91 Honda Accord ignition module replacement?
how to put in a ignition on a Honda accord 1991
How do you replace a ignition switch tumbler 1991 skylark?
how do you replace a ignitionswitch tumbler 1991 buick skylark
How do you replace an ignition switch in a 1991 Volvo SE Turbo Wagon?
replace ign sw on 1991 volvo 240
Why is there no spark in a 1991 Jeep Cherokee?
Replace the ignition coil.
How do you bypass the resistor in the key ignition on a 1991 firebird?
buy a DFVATS Bypass Module from www.bakerelectronix.com
How do you replace an ignition switch for a 1977 Chevrolet truck?
n ignition switch on a 1991 Chevrolet astro vanAnswern ignition switch on a 1991 Chevrolet astro van
