First, carefully pry up the switch console on the side that is affected, i.e., driver's side front and back windows are controlled by the left set of switches, passenger windows are on the right set of switches,
Use a small jeweler's style or similar flathead screwdriver for this task, and pry from the bottom of the oblong shaped plastic piece that the two switches are mounted upon. Small, gentle prying amounts applied a little at a time will assure that the switch and the mounting area remain undamaged.
Once the switch console is removed (quite often this is the driver's side set, due to heavier use), carefully pull the wiring harness up a few inches to reveal the Molex style modular plug mounted on the bottom of this unit.
Gripping the modular plug between your thumb and forefingers, grip and squeeze inwards to release the plastic tabs on either side of the plug, then gently wiggle the plug front to back while pulling downward to completely remove the plug from the wiring harness.
Unfortunately, no repair of the individual switches are possible, as this is a sealed unit that contains both the front and rear window switches, however, once the non functional switch console is replaced with a new (or used from a place like pullapart.com) unit, reinstalling it is a breeze. Simply reconnect the modular plug at the bottom to the wiring harness and gently pop the switch console back into place.
Defective passenger power window switch. It is stuck in the down position. Raise the window and immediately disconnect the switch until you can replace it.Defective passenger power window switch. It is stuck in the down position. Raise the window and immediately disconnect the switch until you can replace it.
How do I replace the power window switch on 1977 Corvette coupe
Your switch could be worn out you would have to replace the rocker to the switch or replace the whole window switch console.
The led light in the window switch is not replaceable. It is only serviced with the entire switch.
Do you mean the main switch by the driver or the switch on the door itself?
First test to see if the problem is the switch, wiring, or the motor. Here's howhttp://www.ricksfreeautorepairadvice.com/repair-topics/window-power-repair/test-power-window-motor-and-regulatorThen replace the regulator if the switch and wiring test good. Here's howhttp://www.ricksfreeautorepairadvice.com/repair-topics/window-power-repair/replace-a-power-window-motor-regulator
pry out the control switch and disconnect the electrical connectors.install is reverse.
The switch is burned out. Replace it.
Broken regulator. REplace it. Here's how:http://www.ricksfreeautorepairadvice.com/repair-topics/window-power-repair/replace-a-power-window-motor-regulator
you must determine weather the switch or window motor is bad and replace.
you should be able to take the cover off the driver's door by unscrewing it,then unplug the window switch and replace it,fairly easy..
Replace the switch.