the control head needs to be removed and the bulbs are on the back. just turn them less than a quarter turn and knock them out.
The Pontiac G6 block heater is located on the right hand side of the engine. The block heater can be located by following the block heater cord.
I can't find my block heater plug on my pontiac G6 2006,,,Where is it? Maybe it does not have a block heater.
how do you replace license pate light on 2006 pontia g6
what about it? if its on, your traction control is on & working. if its not, then its not!!
my g6 heater and shifter console does not light up
Traction Control
There are three rubber caps in the inside of your trunk. Remove the caps and with a long 10 mm socket unscrew the two two nuts and one screw. The entire light fixure slides out and you turn the bulb socket. To replace the bulb use a Silvania Long Life bulb. You pull the bulb out and push the new bulb in till it snaps. Check the light functions before reinstalling. Good luck, easy fix.
Be careful not to handle the bulb with your bare hands. The grease from your fingers will effect the life span of the bulb.
go into the trunk and disconnect the wires and then pull the speakers out from the trunk and replace.
Unplug the harness that goes to the bulb. Pull off the rubber sealer. There's a wire clip that goes along the bottom side of the bulb to hold it in place. Push that clip in (towards the front of the car) and down to release it. Pull out the old bulb. Insert the new bulb the same way: with the missing electrical pin at the bottom. Twist it back and forth to make sure it locks into place. Replace the clip by pushing in and up until it clicks into place. Replace the rubber sealer. Push around the entire edge until it snaps into place. Replace the wire harness.
Either from the dealer or a parts yard
The PCV is non-serviceable. It cannot be replaced.