0
How to replace intake manifold gaskets on 1994 cutlass supreme?
Wiki User
∙ 14y ago
My '96 is in the shop with the same problem. Bending me over for 400 bucks
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you replace a axle on a 95 olds cutlass supreme?
How do you replace a axle on a 95 holds cutlass supreme
How many oxygen sensors are there on a 93 cutlass supreme?
Located on the exhaust manifold.
What is the cost to replace a ball joint on a 1991 cutlass supreme?
price on replaceing ball joint 1993 cutlass supreme
Can you switch one ecm with another out of the same type car 1993 olds cutlass supreme?
i need to replace the ecm on a 1993 olds cutlass supreme,can i replace it with another ecm from another olds cutlass?
The oil is milky in your 1996 olds cutlass supreme is it the head or manifold intake gasket the needs replaced?
It could be either one. However, it is well known that these years of V6 engines had weak intake manifold gaskets from the factory. You might just luck out and it'll be the intake gaskets. You could also do a compression and leak down test to check the head gaskets before tearing it that far down to only find out they were fine.
How do you unlock the air compressor on a 1994 Oldsmobile Cutlass Supreme?
you can't you have to replace it!
Can i replace my 95 cutlass supreme transmission with a 92?
no it ruins the steering wheel
How do you replace turn signal lever for a 1994 olds cutlass supreme?
nevermind
How do you fix an oil leak for a 1995 Oldsmobile Cutlass Supreme We think it's the o-ring but we're not sure please give all suggestions?
Not sure if this is your problem, but my 1996 Olds Cutlass Supreme leaked coolant into the oil. This was caused by broken intake manifold gasket. Apparently they're somewhat notorious for developing leaks. That repair required taking the top half of the engine apart. Not sure where your leak is, or how much it's leaking, but you may want to consider the intake manifold and head gaskets.
Location how to replace oxygen sensor 83 olds cutlass supreme?
Start at the exhaust manifold and follow the exhaust from the manifold rearward. You will find the O2 sensors. It may be mounted right on the manifold or somewhere on the exhaust pipe. Looks like a spark plug base with a single wire attached. Unhook the wire and use a boxed end wrench to unscrew & remove/replace the sensor.
Can you put any oldsmobile motor into a 1985 cutlass supreme?
No you can not put any Oldsmobile motor into a 1985 Cutlass Supreme. Each car has a motor that was designed specifically for that vehicle. So if you need to replace the motor in a 1985 Cutlass Supreme, you need to find the specific motor for that vehicle.
How do you change the lower intake gasket on a 95 Olds Cutlass Supreme 3.4DOHC?
Remove the 1995 Oldsmobile Cutlass intake manifold retaining bolts. The manifold will come off. Remove the old gasket. Clean the surface. Put the new intake gasket and tighten the intake manifold retaining bolts.
