When your car is serviced at a non-vw garage or at home by yourslef, the ecu doesnt know its had a service, so the service indicator stays on. To reset it:
-(with the ignition off and keys out) press and hold the mile reset button
-turn ignition on
-wait until the display goes like '--'
-turn ignition off and keys out and release button
You need a scan tool to reset light after repairing the code.
To reset service light on Toyota Auris one can activate the code error reader which is a diagnostic tool. You can also hold down the odometer reset button.
You repair the cause of the code, then reset the code with a scan tool or by unhooking the battery.
The service engine or check engine light can be reset with a scan tool or by unhooking the battery. The light will return if the failure that caused the code is not repaired.
Just press the trip reset button
Most any code reader that plugs into diagnostic port can reset
Most OBD2 code scanners give you the option of clearing the code and resetting the MIL.However, if the problem still exists the light will come back on.Repair the problem and the computer should reset the light.
After the cause of the code is repaired, the light is reset with a scan tool.After the cause of the code is repaired, the light is reset with a scan tool.
After repairing the cause of the code, you clear the code with a scan tool.
After repairing the cause of the code, you can clear it with a scan tool.
Figure out what tripped the code and fix the problem
by connecting an OBD II code reader