my 1985 ford crown Victoria ignition has locked up! what do i do?
Do you mean the electrical ignition switch or the cylinder lock and key..?
you have to replace your spark plug wires there is a coil on each wire for each cylinder.
Begin by removing the retaining ring at the top of your 1994 Ford ignition lock cylinder. The ignition lock cylinder will slide out. Remove the wiring harness from the end of the ignition lock cylinder. Reverse the process to install your new ignition lock cylinder.
8 -------------------------------------------------------------------- If you have a 1998 or newer Ford Crown Victoria that has the Coil On Plug ( C.O.P.) ignition system there are ( 8 ignition coils ) as mentioned above Before that the 4.6 liter in a Ford Crown Victoria had ( 2 coil packs )
Ignition what?CoilControl moduleSwitchLock cylinderSee "Related Questions" below for more
According to the 1998 Ford Crown Victoria Owner Guide : With engine oil filter change : ( 5.0 U.S. quarts of 5W-30 )
Remove the retaining ring, from the top of your 1997 Ford Astro ignition lock cylinder. Remove the wiring harness from the back of the ignition lock cylinder.
Unless you want to lose your $1200 air bag, take it to an authorized mechanic.
For a 2000 Ford Crown Victoria : 1 - 3 - 7 - 2 - 6 - 5 - 4 - 8 It has the Coil On Plug ( C.O.P. ) ignition system with ( 8 ) individual coils The engine cylinder locations are numbered : firewall 4 - 8 3 - 7 2 - 6 1 - 5 front of Ford Crown Victoria ( V8 )
On a 2001 Ford Crown Victoria : The firing order is ( 1 - 3 - 7 - 2 - 6 - 5 - 4 - 8 ) The engine cylinder locations are numbered : firewall 4 - 8 3 - 7 2 - 6 1 - 5 front of vehicle A 2001 Ford Crown Victoria has the Coil On Plug ( C.O.P. ) ignition system with ( 8 ) individual coils
In a 1993 Ford Crown Victoria : ( 2 valves per engine cylinder , total of 16 valves )
On a Ford Crown Victoria : firewall 4 - 8 3 - 7 2 - 6 1 - 5 front of vehicle
On a 1995 Ford Crown Victoria : There is no distributor , it has an Electronic Distributorless Ignition System ( EDIS ) with ( 2 ) ignition coil packs that have four towers on each where the spark plug wires connect
I'm wondering if a locksmith is capable of getting your ignition lock cylinder to rotate to the on/run position so the ignition lock cylinder release can be depressed to remove it ? I'm also wonderering what they would charge for that service, because I was charged $30.00 and taxes to open my door lock on my house.
screwdriver or punch
The 1997 Ford Crown Victoria owners manual shows ( 5 w 30 )
Removing a ignition lock cylinder from a 2002 ford windstar with no key
I'm wondering if a locksmith is capable of rotating the ignition lock cylinder to the on/run position so the release can be depressed to remove the ignition lock cylinder, or if a locksmith can make an ignition key for the existing cylinder ? I'm also wondering what it would cost. I was charged $30.00 and taxes to come to my house and unlock my doorknob lock this year. Something to check out.
The 1981 Ford Crown Victoria does not have an Oxygen sensor.
Could be a bad ignition coil each cylinder has its own