answersLogoWhite

0


Best Answer

If it's a regular chopsaw, it's cut will be about 9 ".

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How wide of a board can be cut with a 12 chop saw blade?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

To make a wide groove in a board with a table saw what type of blade would you use?

A dado blade. A dado blade is 2 saw blades sandwiched around a number of "chisel" blades added or subtracted to achieve the desired width of the saw cut.


How do you cut paving brick?

A chop saw with a masonry or diamond masonry blade works well. They're available at rental stores.


How do you do Julian cuts?

Julian cuts are 1/8" wide strips. Best cut with a slice, not a chop.


To cut with a quick blow?

It is to CHOP


Tile saw and cut off saw?

Tile saw, the blade runs in water and is like a small table saw. Cut off saw can use water but usually is dry and is a chop saw. The blade come down into the tile or brick which is in the stationary base.


How do you make a sentence with the word board?

That board is not wide enough. I have a wider board. The board still needs to be oak. This board cannot be cut any longer.


What exactly is a paper cutter?

A paper cutter is a board that has a blade attached to it as well as lines on it that can be used to meause and cut paper. Theplacement of the blade makes it so that typically the only thing being cut is the paper.


What knife do you use to cut carrots?

I use a thick bladed 9" chefs knife. Always chop hard vegetables with a rocking motion to the knife. Set the point of the knife down to the cutting board and use this point as the pivot for the knife, rocking the blade up and down. NEVER chop by lifting the knife off the board and chopping down like an axe, this will dull the knife in no time, and is dangerous, as a slip could relieve your other hand of it's fingers. **The only exception to this is in using a cleaver which must cut through bone.


When was Chop Cut Rebuild created?

Chop Cut Rebuild was created on 2004-02-19.


Can you put 20 inch mower blade on 21 inch mower?

Yes, it just won't cut as wide.


What is a 4 letter word for a cut with a quick blow?

It means chop


What are the dangers of a chop saw?

There are several dangers associated with a chop saw. If the blade is dull, the wood might get spit out and hit the operator. There is the danger of losing fingers from not following safety guidelines. There is also a danger of sawdust getting into the eye. A portable chop saw can cut off limbs if the guards are not in place.