Hip and shoulder are both Ball and Socket Joints
If the joint between your arm and shoulder was not a ball and socket joint, you could not be able to move your arm. Ball and socket joints allow you to move in most directions. Because of this, you can move your arm up, down, side to side, front and back, and around in a circle. The ball and socket joint is one of the four major kinds of movable joints. (The four major joints are ball and socket joints, gliding joints, hinge joints, and pivotal joints in case you didn't know.)
Ball-and-socket joints can be found in the shoulders and hips.
ball-and-socket joints
4: the shoulder joints and the hip joints.
the ball joints are not serviceable.
Factory ball joints do not have a grease fitting. If yours have been replaced, it is then possible it will have a fitting.
Sealed ball joints are not designed to have grease added. They have been permanently sealed, and can only be replaced when there is a problem.
all the ball joints are self lubricated, meaning no grease fittings, you cannot grease them or the steering joints, you can grease the front and back u joints on the drive shafts,but that is all.
Lower ball joints. Grease nipple is accessible from the front
that vehicle has a total of 11 grease fittings. two upper ball joints two lower ball joints, two outer and two inner ball joints, two on the idler arm and one on the pitman arm.
If it has any they would be on the tie rods and ball joints.
EP2 grease is a type of non-corrosive lithium grease. Its main usage is in cars, more specifically for car parts like ball joints, U-joints, CV joints, etc.
A grease gun end goes right on the fittings.
they are greaseless
a grease fitting is something that u put a grease gun into and pump grease into it to lubricate ball joints, steering knuckles ect...
Factory unit is sealed without grease fittings Replacements have grease fittings