Place a drip pan below the oil pan in your 1988 Chevrolet. Remove the oil pan plug. Allow the oil to drain out. Put the plug back into the bottom of the oil pan. Fill the motor with new oil.
It's on the side of the motor
If the cubic inch is the same the motors should swap out ok. You will have to change some parts but most Chevy motors will swap.
Yes. A rear end from a 1984 Chevy 1500 can fit in a 1988 GMC Jimmy 1500.
5 quarts
No way, Not even close.
In 1988 there was a body style change , if the 1988 is the new body style then Yes you can.
10,400 lb
The oil pressure sensor on a 1988 Chevy 1500 5.7 is located on the engine. It is on the right side, near the intake manifold.
No, the rear section is different.
How do i change the ignition switch in a 1988 Chevy camaro
From 1988 to 1999 will fit.
try www.haynes.com