Yes. A rear end from a 1984 Chevy 1500 can fit in a 1988 GMC Jimmy 1500.
No way, Not even close.
10,400 lb
The oil pressure sensor on a 1988 Chevy 1500 5.7 is located on the engine. It is on the right side, near the intake manifold.
No, the rear section is different.
From 1988 to 1999 will fit.
try www.haynes.com
If the cubic inch is the same the motors should swap out ok. You will have to change some parts but most Chevy motors will swap.
Chevy did not use an Idle Air temperature sensor on that year.
1988 through 1999 Chevy TRUCKS have the same chassis
75w or higher gear oil
DEXTRON II fluid.
In a manual for that vehicle.