0
How would you pressurize the system at the main water supply line?
Wiki User
∙ 11y ago
If you are talking about a normal house, all you need to do to 'pressurize the system' is turn on the main valve, then open up each tap/faucet in turn until water is flowing freely.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Do you pressurize the bladder in a G E homespring water filtration system with or without water pressure in the unit?
Mine came new with air pressure in the bladder & no water in the unit so I would assume that you would pressurize the bladder with no water in the unit . Hope this helps .
What happens if you continue to pressurize water?
You end up with water that is under pressure. Time would have no affect on the process.
What is a root like system of threads which supply moss with water and nutrients?
That would be the rhizoids.
In area where water supply is poor during periods of peak demand what type of system would usually be specified for the domestic dwelling?
In area where water supply is poor during periods of peak demand what type of system would usually be specified for the domestic dwelling?
In area where water supply is poor during periods of peak demand what type of system would usually be specified for a domestic dwelling?
secondary cold water system
Why did farmers need to develop a system control their water supply?
Irrigation is a system that was needed to transport water to a section of land that is being used to grow crops. This system is controlled because there is such a thing as too much water and too little: Too much and the plants will drown, too little and the plants will not grow or be stunted..
If all the water vapor in the atmosphere were to condense and fall to the ground the globe would be covered with about how much water?
we would flood since we have a hog water supply we would flood since we have a hog water supply
Can you turn the main water off and leave your furnace on?
This depends on the type of furnace system you have. A forced-air furnace should be completely independent of the water system. An older, convection-based (no pump) hot water system will have an expansion tank, and will not need to have the main water on, except to replenish the system, which should happen infrequently. A closed-loop system could possibly over-pressurize as the water is heated, with the mains valve closed, and would trigger the pressure relief valve, dumping a few cups of water every time the furnace cycles until the system was dry; eventually, with the pipes in the furnace dry, the furnace heat would melt and destroy them.
What would happen to a sample of water at 30 degrees c if it is heated until the temperature reaches 120 degrees c?
It would heat to 100 degrees C, and then begin to boil. The water vapor would be at 100C, and would rise away. If you kept the vapor combined, it would pressurize the container.
What would cause the fuel pump to not pressurize?
there could be some leakage in the pump
What would happen to your water supply if land use was not regulated?
If land was not regulated, then there could be more pollution. Polluted areas would cause the water supply to be unusable and undrinkable if runoff from chemical sources enter into the supply.
Why would there be hot water in the tanks of the toilets in a recently purchased house?
Someone hooked up the hot water supply to the toilet instead of the cold water supply- or your water heater is back drawing hot water through to the toilet from a cold water inlet (supply)
