answersLogoWhite

0


Best Answer

don't use LC

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How you can make a oscillator without using LC?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Physics

Differetiate between LC oscillators and crystal controlled oscillators?

difference between local oscillator and controlled oscillator


What is role of LC circuit in the hartley oscillator?

Self-tuning feedback


What is difference between series fed and shunt fed hartley oscillator?

The DC voltage for the amplifier (transistor or FET) runs for a series-fed oscillator through the inductance of the LC circuit. A shunt-fed oscillator uses a radio-frequency choke or a resistor to deliver DC voltage to the amplifier. For an oscillator the difference between serial-fed and shunt-fed is small. The choke resonance frequency can interact with the LC circuit resonance frequency. This problem happens only with shunt-fed. Furthermore series-fed needs less components. Therefore it is prefered for (low power) oscillators. The output circuit of an amp can be series-fed or shunt-fed, too. The additional DC current through the coil will drive a iron or ferrite core earlier into saturation. This is an disadvantage of serial-fed. At a high-voltage tube RF amp with say 2000V DC voltage, in the shunt-fed amp only the choke and the DC blocking capacity have to withstand the high voltage. This is an advantage of the shunt-fed solution.


What is Franklin oscillator?

It is an electrical oscillator which uses two transistors or vacuum tubes and a LC circuit. The two transistors are connected as a two stage amplifier, both stages are inverting. the output of the second is coupled to the input of the first by a tuned circuit. Provided the amplifiers have enough gain, the circuit will oscillate, because the two amplifiers each give 180 degree phase shift, so the output is in phase iwth the input, so the oscillations build, until they are limited in amplitude by gain compression.


What is the difference between oscillator and feedback amplifier?

There are two differences: a) the amount of feedback you allow b) whether you wire a frequency-determining device into the circuit First things first: ANY amplifier circuit that uses feedback, which these days is most of 'em because feedback improves the quality of an amp's output, will oscillate if there's enough feedback. This poses a real problem because the more feedback you use, the better the amp sounds. Your challenge, therefore, is to make an amp that uses not quite enough feedback to oscillate. The other is equally critical. If you want oscillation you usually want it on a specific frequency. You can build an LC tank or a crystal into the circuit to determine the output frequency if you're building an oscillator; if you're building an amp you wouldn't do this.

Related questions

Classification of oscillators?

Phase-shift oscillator Armstrong oscillator Cross-coupled LC oscillator RC oscillator


What is a frequency range of LC oscillator?

depends on the oscillator and its purpose


What are the Difference between RC oscillator And LC oscillator?

The difference between an RC and LC is that the frequency - determining device in the RC oscillator is not a tank circuit. LC can operate with A or C biasing, while RC can only operate with A.


What is type of oscillations?

Phase-shift oscillator Armstrong oscillator Cross-coupled LC oscillator RC oscillator


What the major components of a colpitts oscillator?

1.CE amplifier circuit 2.LC oscillator circuit


Differetiate between LC oscillators and crystal controlled oscillators?

difference between local oscillator and controlled oscillator


What is role of LC circuit in the hartley oscillator?

Self-tuning feedback


What is a Colpitts oscillator?

A Colpitts oscillator is the electrical dual of a Hartley oscillator. The Hartley oscillator is an LC electronic oscillator that derives its feedback from a tapped coil in parallel with a capacitor. http://en.wikipedia.org/wiki/Colpitts_oscillator http://en.wikipedia.org/wiki/Hartley_oscillator ~MECHASUN~ A Colpitts oscillator is the electrical dual of a Hartley oscillator. The Hartley oscillator is an LC electronic oscillator that derives its feedback from a tapped coil in parallel with a capacitor. http://en.wikipedia.org/wiki/Colpitts_oscillator http://en.wikipedia.org/wiki/Hartley_oscillator ~MECHASUN~


State four types of LC oscillators?

Four types of LC oscillators include voltage controlled oscillators, drift control oscillators, crystal oscillators, and tuned circuit oscillators. A tuned circuit oscillator is the most common type of oscillator.


What is a local oscillation?

A local oscillator is used in a superheterodyne radio circuit for example.The incoming radio frequency is mixed with an internal local oscillator circuit to generate a new intermediate frequency (IF) .The local oscillator usually runs at a frequency of 470kHz and is generated by an inductor and capacitor(LC oscillator)


What is local oscilator?

A local oscillator is used in a superheterodyne radio circuit for example.The incoming radio frequency is mixed with an internal local oscillator circuit to generate a new intermediate frequency (IF) .The local oscillator usually runs at a frequency of 470kHz and is generated by an inductor and capacitor(LC oscillator)


Why LC oscillator not suitable for audio frequency?

Another type of sine-wave generator uses inductors and capacitors for its frequency-determining network. This type is known as the LC OSCILLATOR. LC oscillators, which use tank circuits, are commonly used for the higher radio frequencies. They are not suitable for use as extremely low-frequency oscillators because the inductors and capacitors would be large in size, heavy, and costly to manufacture.