Want this question answered?
25
The transformer doesn't "boost" energy. If the voltage on the output side is higher than the voltage on the input side, then the current is lower. The power (energy every second) on either side is the product of (voltage) times (current), and that product is the same on both sides of the transformer.
You draw a rectangle and then you divide it into to 2 equal parts (split it down the middle). After you do that you label the input side x and the output side y. And now you got an input output chart.
For an electrical transformer the ratio of the coils on each side is the same as the ratio for the voltage change.
Assuming the input side of the lever remains the same length, the reduction in distance you specify will reduce the input effort needed. If the input and output lengths from the fulcrum are respectively L and l (small 'L') long, and the input and output forces are respectivelyf and F, then Lf = lF So to maintain that algebraicequality, reducing l will increase F for the same values of L and f.
I think you mean 'turns' rather than 'coils' (a coil is made up of a number of turns). The answer is that, yes, the turns ratio is the same as the voltage ratio, for an ideal transformer.
an impedance common to both input and output can be slit into two (input alone and output alone) by using miller theorem.at the i/p side impedance multiplied by 1-gain and output side it is done by 1-1/gain.
Let me first correct the question "current" here should be "tension" current is the speed of the electrons moving through the conductor and tension is the EMF that make the electrons move you cannot input current. the current is the demand of the circuit, depending on the resistance and the EMF(Electro Motoric Force) in other words, the Volts that is applied or input to the circuit.Answer:Any transformer can be used as a up step(inverting) or down step(converting) transformer, for instance 220V - 6V will be a converting and the 220V side will be your primary or high tension input and if you turn it around the 6V side will be your primary or low tension input.
The 78xx regulater can be used as a constant current source, by connecting the output to the input side of a series resistor, and the "ground" to the other side of the resistor. Do not connect the "ground" to real ground - leave it floating.Since the 78xx maintains a constant voltage differential between output and ground, there would be a constant current through the resistor.
A causal system:-is a system where the output depends on past and current inputs but not future inputs i.e. the output only depends on the input for values of .or in simple, the right side of sequence in a system is causal system!!
They are on the driver side of the transmission.
You can't determine the output voltage of a transformer by knowing kva. Transformers will be marked as to input and output voltages. Some will have multiple input and output voltages. The output voltage depends on the ratio of coil turns between input and output.