The use of transmission gates eliminates the undesirable threshold voltage effects which give rise to loss of logic levels in pass transistor logic.
Non restoring
Transistor with 2 gate on top and bot of the channel
An AND gate is a logic gate performing a Boolean logic AND operation.
universal logic gate is a gate using which you can make all the logic gates there are two such gates NOR gate and NAND gate
A CMOS gate is a logical switch used in electronics. CMOS stands for Complimentary Metal Oxide Silicon. These types of semiconductors have a very high input impedance, are very sensitive use low current and work over a larger range of voltage. The alternative is TTL(Transistor to Transistor Logic) which work at 5volts only and draw higher currents. A gate, is a switch that changes state (on/off) depending on the logic voltage levels applied to it's inputs.
An XNOR gate is a logic gate performing a Boolean logic XNOR operation, also known as an equivalence gate.
When the two input terminals of a NAND gate are short circuited, it acts as a NOT gate.
the gate delay is the time from applying the signal to the input and getting the signal at the output digital implies on or off so when the signal goes to the input it takes a bit of time to rise to a sufficient level to saturate the transistor there is also a bit of capacitance present so the transistor takes time to drain off all the charge the smaller the less delay
yes The logic gates AND OR NOT ExOR can be used as gate for electrical signal whether it may D.C value or A.C signal. Both can be processed by a digital circuits . the logic gates are fabricate from cmos transistor. and they perform logical operation on applied signal
The 74xx series of integrated circuits use 5 volts. This is common in TTL (Transistor to Transistor Logic) circuits.For inputs:The 0 or Low Logic level is anything less than 0.8vThe 1 or High logic level is anything from 2v up to the supply or 5v level.Voltages between these trigger points in the logic, should be avoided to prevent spurios operation.The output levels are generally5v = logic level 1 or High0v = logic level 0 or Low.
The switching time (on and off) of the TTL logic gate is very fast in comparison with CMOS logic gate. However, they could not tolerate higher range of power supply.
AND gate is an all or nothing gate because in able to have an output of logic 1,all of the input must be all logic 1 or else the output will be nothing or simply logic 0.