0
If you buy the wheel hub and bearing in one assembly its real simple to change it.
- Remove wheel
- Remove brake caliper, brakes and brake mounts
- Remove drive axle nut (may need to get a new cotter pin if there is one already there)
- Unbolt the balljoints, 2 bolts located at the bottom that connect the control and steering arms to the wheel.
- Use a balljoint separator (basically a wedge) to pop loose the balljoint and arms.
- Pull the wheel out of the driveaxle, now the wheel can be angled so you can access the hub bolts.
- Break those loose, then remove the hub and rotor
- there are a couple of ways of separating the rotor and rotor: use two bolts (M8*1.25, I think) and screw into the two small holes located near the center, it should pop the hub loose. That didn't work for me, so I just sat the rotor between two bricks and used a soft mallet to bang out the center.
- Reverse the steps and that's it.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you change a rear wheel bearing on a Mitsubishi Galant?
dealer
How do you take off a back wheel bearing on a 1986 Mitsubishi Galant?
with a punch and a hammer
Where is the wheel hub assembly on a Mitsubishi Galant?
Behind the wheel?
How to replace a wheel bearing in a 1994 Mitsubishi Eclipses?
Just get a new hub from a junkyard.
How do you replace a front wheel bearing on a Mitsubishi L200?
They very rarely need replacing, just adjusting
You have a 2002 Galant you've had to replace the wheel bearing 3 time in 2 years What's causing the bearing to fail?
Improper installation. Not torqued correctly. Torque to factory specs. Did you also replace the race on which the bearing rides? If not, this is your problem. A bent wheel, bad tire, or bad strut or shock can also cause a bearing to fail prematurely.
What size is steering wheel nut on 2001 Mitsubishi Galant?
17 mm
How do you replace a rear wheel bearing on a 2001 Mitsubishi spyder?
Remove axles and wheel with leverage bar. Remove caliber assembly. After removing the entire front mechanisms. Replace them with new, and reassemble tires.
How do you unlock your ignition lock to your steering wheel on a 1997 Mitsubishi galant?
Edgedarrius@yahoo.com
Do you need to replace the wheel bearing when replacing brake discs on a mark 4 golf gti?
no need to replace wheel bearing unless the wheel bearing is worn out
How do you replace a rear wheel bearing on Mitsubishi Endeavor?
just undo the four bolts holding it in, they are accessed at the axle end of the hub. it comes as an assembly.
How do i replace therear wheel bearing on a Chevy pick-up?
how do you replace the rear wheel bearing on a Chevy pick up
