Replace the lock solenoid. Consult your service manual.
unhook neg battery cable then wait 10 mins for disgarge of capaciter then proceed to change ignition
First unhook the battery. Then put the key in (you need it!) and turn it to "on." Remove the steering wheel and the ignition switch just slides out.
Scan tool or unhook the batteryScan tool or unhook the battery
Never unhook the battery with the ignition turned on. There is always a little voltage spike that occurs when disconnecting or reconnecting the battery. If the ignition is on the computer will be powered up and that spike could "fry" the computer.
You can unhook the battery or use a scan tool.You can unhook the battery or use a scan tool.
Unhook the battery for a few minutes.Unhook the battery for a few minutes.
Remove cowling from under the steering wheel, remove the two nuts holding the wheel coloum. Drop the steering coloum. Ignition switch is about a foot down on the left side. Unhook the wires remove switch replace. P.S. Unhook battery cables high voltage in ignition system.
With a scan tool, or unhook the battery for 5 minutes.With a scan tool, or unhook the battery for 5 minutes.
while the car is running unhook the negative battery cable. If the car remains running then your alternater is good if it stalls then replace it.
You can use a scan tool, or unhook the battery.You can use a scan tool, or unhook the battery.
You can use a scan tool or unhook the battery.You can use a scan tool or unhook the battery.
You can use a scan tool, or unhook the battery for ten minutes.You can use a scan tool, or unhook the battery for ten minutes.