is the foglight a one piece unit
The dealer said that you have to remove the front bumper in order to even get at the bulb to change it!
=
You need to remove the headlight first. After removing the headlight, you will be able to unplug the power and remove the bulb from the housing. The new bulb comes ready to plug in.
Hi you gota law on your back under the corner thers a flap take that cover off reach your hand inside and twist the bulb socket out its a 881 bulb.
Stupid joke get a job!
There is no "fog light sensor".There is no "fog light sensor".
2008 Hyundai Santa Fe fog light bulb replacement: Purchase the correct replacement fog light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the fog light bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
You'll need to remove the black body trim in the wheel well and underneath the corner of the front bumper to access the back of the fog light. If my memory serves me correctly it can be done through the bottom panel if you bend it firmly and risk shoving and scratching your arm.
Remove the fog light retaining bolt. Remove the fog light wiring harness. The fog light will come out. Reverse the process to install the new fog light.
To install fog light in a 2000 Trans Am, disconnect the fog light switch from the housing. Then remove the washer, bolt, and nut. Finally, remove the fog light housing, twist the fog light off, and replace. ?æ?æ
Fog Point Light was created in 1827.