0
I've replaced the front wheel bearing on my 1997 Toyoto Corolla twice and the hub once with the past month and now it has gone out again any idea on what would cause the bearing to go out 3 times.?
Wiki User
∙ 15y ago
The wheel bearing should have a inner and outer seal to keep debris out. Do you have these installed everytime you replace the bearing? They are highly overlooked but are the difference in having to replace bearings periodicly.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
What and how do you test to find out why the radiator fan will not work on a 91 Toyota Corolla?
probably your termostat isn't working, that's what happend to my corolla. I replaced the termostat and now it's working again..
What does it mean when the brake light and the battery light come on at the same time in a 2000 Toyota Corolla?
The same thing happened to my 1992 Corolla, and it means the alternator needs to be replaced. Although the same thing happened again when the belt went out on my water pump.
Could cam belt have gone again when replaced at 40 - 50000 kms and car died when I was driving a Toyota corolla fx gt?
yah they can go every 5000kms.
Is it true or false that renewable resources can be replaced or grown again?
True. Renewable resources can be replaced or grown again.
Is 2009 Toyota Corolla recommended?
yes because gas is raising up again
How do you reset your 1997 Toyota Corolla VIP alarm so it will start again?
ok
Did Axle get replaced in inazuma 11?
yas he did get replaced but came back again
1990 Toyota corolla driving dies won't start again why?
Died while driving? Alternator
What if the timing belt on a Honda crv was replaced at 95000 and is now 173000 when should it be replaced again?
Soon,
What do you call a resource that people can use again and again and its supply can be replaced?
Renewable resources. Because they can be RENEWED.
How long does it take to replace a clutch disk in a 1989 corolla?
4 - 6 hoursdepends on who is doing the job, if its a pro, i'd allow 4 - 6 hours. i wouldn't only replace the clutch plate, if your in there, you should also do the pressure plate & thrust bearing also, better to do them now, than have all that work done again in a short time.
How do you turn off corolla 2010 lights at night?
Turn off engine, pull emergency breaks then turn engine on again.
