answersLogoWhite

0


Best Answer

I would say you have a short. possibly the fuse box under the hood to explain most of it the only reason the radio would change stations because of this is if there are controls on the steering wheel? Humidity is to blame for many electrical problems.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: I have a 2005 dodge durango the lights inside would not go off Today they are off but the blinkers do not work the radio changes station and it gets louder and louder the whipers do not turn off help?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What are some funny or sarcastic pages on facebook?

- i laugh when the ketchup farts - I hate that little triangle the windshield whipers dont clean - No one's a "Loser"... we are all the sperms that won! - ...


Where is an Audi A4 fuse box?

Open the driver side door. Remove panel on left side of dash. Fuse box is behind panel. 1998 A4 Audi Cabriolet The fuse box is located directly in front of the Steering wheel in the engine compartment. Open the hood. If you are standing in front of the car it would be to your right side at the very back of engine compartment under the windshield whipers. There is a channel under windshield whipers and a black box that is on the far right side. It is easy to miss.


What is after night whipers by Erin Hunter?

The fourth book in the Omen of the Stars Series is said to feature the Tribe of Rushing Water, and is currently called The Sign of the Moon, as revealed on Victoria Holmes' (One of the three erins)Facebook page.


When i start my car 96 dodge neon my Windshield wipers don't turn off and my headlights turn on no turning signals if i turn car on and turn lights on it stalls out if i turn left signal on it stalls?

AnswerAre they all controlled by the multi-function lever (Turn signals)?Sounds like a problem in steering column++++REPly==== no they are not in the same switch the head lights pull out from bottom of the dash bord turning signals on the left side and whipers on the right...i checked fuses and relays and no relay for whipers that i can seeo.m.g how many ppl. reed dis?


How do you install a wiper motor?

At first you have to take off the wiper arms(that is easy to figure ) Then you have to remouve the cowl(that big plastic cove under the whipers) Do do that...after whipers had been tken off,they are 4 or 5 screws in the cowl from the top.Then open the hood,from inside you can lift the cowl Have to be caerfull with edges ,they have clips at the ends...some time they snap easy ,just lift the edges with a screwdriver,be gentille... At this point the wash botlle hoses must be disconected,just pull very caerfull The wiper motor is attach to the cowl...I thing you can figure what to do from here Don't be scared it's not thad hard,it tale some attention and patience... Good luck...


If we replaced ignition switch and cilanoid 1989 Ford Bronco XLT still will not start but light and whipers etc come on?

My 1994 Bronco will do this due to a bad positive connection on the starter (corrosion and dirt) when i clean it and spray some PB Blaster it gets a better connection and starts fine.


Can a car dealership sell a car that has no license plate lights?

No. a dealership must check the vehicle and fix all "safety issues" before selling the vehicle weather it be used or brand new. safety items are things such as safety belts, windshield whipers, tail lights, headlights, door latches, windows(not cracked), airbags, all lights and emergency signals...


How do you change a wiper motor on a 2000 Dodge Caravan?

There should be about 6 philp screw across the whipers plate and a 14 or 15 mm nut on each blade. Once you remove it then open your hood and across the front of that plate you will see about 6 wing nut looking nuts remove them and remove the plate. Now there you will see the rods that makes it work and in the middle of the van there will be the motor but it's hard to see, there are 3 10mm nuts for it. Once you get them off it's easyier if you take out all the nuts and bolts to the entire rod set up so you van get that motor unpluged and out. I just did mine 3 days ago. When you get it all put in and back together make sure you whipers will no hit the other one or you will be doing it all over because the gear in the motors are just plastic and will strip reall fast. Good luck.


My whipers on my Buick century 2002 are stuck up and wont go down?

I had the same problem on my 2000. It seems mine slipped on the studs and would stay in a up position. I simply removed the arms from the studs, ran them a few times so they were properly positioned, and replaced the arms back on in the "home" position.I had the same problem on my 2002 Buick Century and found that it was a broken park tab on the wiper mechanism. We were able to use a small piece of metal to reinforce it.


What does it mean when a dog whimpers all the time?

A dog whipers whenever it's hurt or scared so if a dog whimpers you should probably confort it and give a lot of love and attention.P.S.Add me on facebook or MSN My name is Sora Jeong With the penguin picture THANK YOU!! :P :D


Where is the flasher for the turning signal in a 1992 Chrysler New Yorker Fifth Avenue?

it is on the left hand side of the steering wheel on the same stick as the windshield whipers. by: kristin stark of orange, tx This is a strange spot to put the flasher unit for the turn signals...Open the glove box..look at the fuse panel on the left... It's in that dark hole to the upper left of the fuse panel. I had to take out the screws holding the fuse panel and move it down and out of the way. Then you get to find someone with a smaller hand/arm to feel up into this access hole. It's very tough to see. There are both the four way flasher and the signal flasher located there. Turn on the signal flasher and feel which one is ticking. (you can feel it) If the signal flasher is not working, turn on the fourway flasher and feel it so you don't take out the wrong one. Pay attention to the orientation of the terminal prongs so you will be better prepaired for the replacement of the new unit. Good luck...


What happened with Queen Elizabeth and her stepsister Mary?

Both were catholics but Mary held to a more modern brand of Catholicism. She held that the authority within the Catholic CHurch was held by the Bishop of Rome and this was by Divine Right, or God's Will! This was a recent development and had led to an absorption within the Holy Roman Church of recently added ideas and claims and a total refusal to contemplate S.Paul's Injunction, "Keep the Deposit!" Interestingly, King Henry, Eliza's father and the Church in England had been one of the opponents of this idea, though the arguments had rattled on for 1500 years! What the Eastern Church and the Anglican Catholics held to was the idea of Christ Revelation, being passed on by the apostolic college to the bishops in their Councils, Seven Ecumenical Councils, which is the teaching of the first thousand years before the separation of east and west!