keep yours. order a bottom end short block that's built. Low compression pistons and forged rods.. dont try to swap motors. Then get a turbo. a good ratio for a turbo 420a motor is 8.8:1 good luck.
Only if you also swap out the transmission because of the gear ratio in a v6 tranny is lower causing your engine to rev high
no works just fine with the 3.2 ecu
If both are 3.3 yes they will swap.
in a diesel engine, no power and blowing white smoke, indicates a bad turbo on the engine
Yes.. turbo systems are universal unless your car electric and doesn't have an intake or exhaust system.. however do your research before bolting on turbo system on a gs because if you have the 95 - 99 models the engine is not the best engine to boost.. it is very weak..
It depends on which engine your trying to swap. The 2.2L OHV engine will work in a 99 from a 2002 because it was the same engine. But if it's a Z24 model the 2.2L DOHC engine will not fit a 99 because the 99 used the old 2.4L Quad 4 in the Z24 models and some LS sedan models.
Valves are not seating properly. Worn piston rings, cylinder sleaves and or blown Head gasket
yes.. i have a 99 grand am gt come stock 3400 and i put a 3100 in it.. runs perfect..
i can answer that one the 3400 out of a 2000 grand am will slap right in. there are afew others including the 3400 out of the avalanche
scoupe turbo engine, tiburon's 2.0 engine, 1998-99 Mitsubishi eclipse... all of this engines fit but some modifications have to be done mainly in the engine mounts
you would have to change the heads and timing cover no you dont have to swap heads or timing cover! it is a direct swap! motor has been in the lumina for about a month now its running great!
Though it could be technically possible, it's probably not financially responsible. It would likely cost more than an automatic 1999 Subaru Outback with a rebuilt engine. The main problem would be in changing it from manual to automatic. Or, there are no automatic/manual "engine's", the engine IS separate from the transmission, this is an easy swap provided you have th skills, the wiring harness and ECU will need to be swapped as well.