The Problem may be from one of the sensors get the OBD done at the dealer
and u might require to change TPS or MAP sensor and if your consuming more fuel than usual it may be O2 sensor
so get the scanning done
A sticking accelerator is usually the result of binding throttle cables or a broken return spring. Make sure that these items are ok as a stuck accelerator can be dangerous.
replace the fuel filter and the accelerator cable to the throtle body
A linac, which is a foreshortening of linear accelerator, is sometimes used to refer to that device.
It wont allow it to start or sometimes may start but die when you press on the accelerator.
Bump. I'd like to know, too. Sometimes it does, sometimes it doesn't
Fuel line. Throttle lines of which there are 2. One is the accelerator cable and the other is the return cable sometimes called the idle cable.
Sometimes artificial transmutations will not occur unless bombarding particles are moving at extremely high speeds, and since a particle accelerator can accelerate a particles speed very close to the speed of light, then you would have to use a particle accelerator to make the transmutation happen.
Depends on position of power switch in the console by the shifter....Also depends on vehicle speed and gear you are going into
I think that happens when you are changing gears. If you make the engine goes to 3000 rpm and suddenly release the gas pedal and rapidly press down the clutch pedal. The rev would up. With very noisy sound. Isn't it?
One can purchase Kelly Lane fashions from The Bay and Sears. These clothes can also be purchased online at eBay. They are sometimes also available at Winners.
"Till rolls can be purchased at any grocery store. They are easy to come by and sometimes require special ordering. However, many stores will be happy to order them."
Cable tidies can be purchased from stores like The Warehouse, K Mart and hardware stores. They can sometimes be purchased at electrical supply stores too.