0
Check with your local lawn mower repair shop
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Why is the gas not going in the prime bulb of a Craftsman 25cc Gasoline Weedwacker?
If the bulb is cracked or the line going to it is it will not work, also make sure the hose going to it is submerged in the fuel. another possibility is that the vent hose is plugged and the tank has too much vacuum pressure to allow the fuel to be sucked up.
What is fuel line diagram for Craftsman Weedwacker 32 cc?
Diagram showing where the lines from the fuel tank go at the carburetor and the primmer bulb.
Why does your Craftsman 4.5 HP model 917.388040 lawn mower start when priming the bulb but then quits after 2-3 seconds The engine will stay running if continued bulb priming.?
The fuel filter is probably clogged. The primer bulb creates enough suction to feed fuel to the engine, but the vacuum created by the piston is not enough to keep the fuel going.
Why does your Craftsman 4.5 HP model 917.388040 lawn mower start when priming the bulb but then quits after 2 3 seconds The engine will stay running if continued bulb priming?
Float is stuck , carb need a good cleaning. If you get lucky might get away with a good in tank carb cleaner. Good luck
Primer bulb is pumping gas in the wrong direction on your craftsman 25cc weedwacker?
I could assume this problem may lie in the pressure used on the primer bulb. Try steady, slower pressure on the bulb... . New info. Just was working on my neighbors unit. same problem. we thought it was dirt clogging carburator. cleaned every thing and blew air through everything. still no prime fuel to the carb. got looking around and all the fuel lines in the tank had disintegrated from setting in the garage for a few years with fuel in the system.
What is the oil to gas ratio for a craftsman 17 25cc weedwacker?
If it was made in the last five years or so, it should be 50 to 1. The above answer is incorrect for my Weedwacker. Craftsman Weedwacker 17"/25cc Gas Line Trimmer 2003 US EPA PH2 Family: 3PWES.0254TZ Disp: 25cc : EM Serial: [redacted] Model: 358.795543 Emission: durability period 50 hours Customer questions: 1-800-235-5878 IMPORTANT! Mix CRAFTSMAN 40:1 2-cycle engine oil with unleaded gasoline. Read oil container or operator's manual for proper mixing instructions. Other oils may cause engine damage. 1. Place stop switch in "ON" position. 2. Set unit on flat surface. 3. Slowly press the primer bulb 6 times. 4. Move choke lever to "FULL CHOKE" position. 5. Squeeze throttle trigger fully and hold [thru step 6] and pull starter handle sharply until engine attempts to run. NO MORE THAN 6 PULLS. 6. Move choke lever to "HALF CHOKE" position and pull starter handle until engine runs. 7. Allow engine to run for 10 seconds, then move choke lever to the "OFF CHOKE" position. TO STOP ENGINE MOVE STOP SWITCH TO "OFF" POSITION. The above three paragraphs are verbatim from three stickers on my Weedwacker. The stickers have no copyright on them. The simple answer to your question is, "40:1 2-cycle engine oil with unleaded gasoline." rcpao 2008-06-29 22:03
What direction does the fuel flow into a weed-eater primer bulb?
Well, I just figured out why my Toro Weedwacker wouldn't run, The fuel hoses were backward, My brother had it for a while then told me it stopped running. He apparently tried to FIX it but accidentally reversed the fuel lines so.1. Fuel comes out of the tank and goes directly into the bottom of the Carb,2. Fuel is pulled through the carb from the side tube on the carb into the priming bulb.3. Once the priming bulb is full the fuel is then returned directly to the tank through a hose which protrudes into the tank about 2 ".4. Ran fine after I got the hook up correct.
How do you replace fuel primer bulb on 32cc weed wacker?
primer bulb replacement on craftsman 32 cc week wacker
Where can you find a priming bulb for a 3214 McCulloch chain saw?
Your local lawnmower and gardening tool store would have that, or be able to get one in easily.
Why does your Craftsman 4.5 HP model 917.388040 lawn mower start when priming the bulb but then quits after 2-3 seconds The engine will stay running if?
You just buy a carburetor re-build kit, clean all the parts and follow the simple directions to puy it back together. You can doi it, it's just not that hard and beats spending 250 bucks for a new mower!
What type of light bulb goes in a craftsman model 536886350 snow blower?
Sources only list the entire assembly as a 581575MA. The bulb should be marked on the metal part with its number.
Where is the choke on a craftsman lawn mower?
depends on the engine Briggs or tech, does it have a primer bulb. but safe bet right next to the carb.
