are supplied by circuits on oppsite legs of the service entrance panel . if each load draws 30amps ,what is the current flow in the neutral wire
The sum of all loads, if it is a shared neutral wire and the two phases are 180 degrees out of phase with each other.
Yes. In almost all cases, the current follows the voltage waveform. The peak amplitude of the current depends on the device or appliance that's drawing the current.
General assembly drawing. General Arrangement Drawing
As the lamps are identical, and all three draw a current of 6 A, then each lamp must be drawing 2 A. So, with one of the lamps disconnected, the current drawn from the supply will reduce to 4 A.
Voltage is current times resistance, 1.2 x 110 = 132 volts.
drawing materials r those through which we do drawing..........n we use it by ourself
A Combined Services Drawing, or CSD, is used in construction. It is an illustration that provides a visual way to look at proposed development plans.
Drawing back the bushes revealed a secret entrance to the cave.
A Combined Services Drawing, or CSD, is used in construction. It is an illustration that provides a visual way to look at proposed development plans.
Then something is turned on and drawing current.
The blower motor is going bad and drawing too much current.The blower motor is going bad and drawing too much current.
There is a short circuit somewhere in the electrical system.
Problem with ac drawing to much current.
You can create individual drawing files for use as blocks.Create a New Drawing FileYou have two methods for creating drawing files:Create and save a complete drawing file using SAVE or SAVEAS.Create and save only selected objects from your current drawing to a new drawing using EXPORT or WBLOCK.With either method, you create an ordinary drawing file that can be inserted as a block into any other drawing file. Using WBLOCK is recommended when you need to create several versions of a symbol as separate drawing files, or when you want to create a drawing file without leaving the current drawing.Change the Base Point of Drawings to Be Used as BlocksBy default, the WCS (world coordinate system) origin (0,0,0) is used as the base point for drawing files inserted as blocks. You can change the base point by opening the original drawing and using BASEto specify a different base point for insertion. The next time you insert the block, the new base point is used.Update Changes in the Original DrawingIf you change the original drawing after inserting it, the changes have no effect on the current drawing. If you expect the original drawing to change, and you want the changes to be reflected in the current drawing, you may want to attach it as an external reference instead of inserting it as a block.Use Paper Space Objects in BlocksObjects in paper space are not included when you insert a drawing as a block. To transfer paper space objects to another drawing, make the objects into a block or save them in a separate drawing file, and then insert the block or drawing file into the other drawing.
Disconnect the cable from the alternator and see if that stops the draw. If it does, the alternator may be defective. Otherwise there may be something else drawing current.
To go into the drawing room while it was empty and before the ladies left the dinner table.
Depends on what is plugged into that plug and the current it is drawing.
A ammeter will tell you how much current draw the load is drawing