When sugar and water are mixed, the sugar dissolves in the water, therefore water is the solvent and sugar is the solute.
The solute is iodine. The solvent is a mixture of alcohol and water. There is no single fixed ratio for the mixture of alcohol and water but it usually is around a 50/50 mixture of water and alcohol with the iodine ranging from about 2% to 7% in concentration.
The solvent is usually the larger part of the solution which dissolves the solute. The solute is the smaller part which gets dissolved. So as an example, seawater is a solution. The solvent is water and the solute is salt and traces of other minerals. Vinegar is also a solution. Again, water is the solvent and glacial acetic acid is the solute. To do acid values in resin chemistry, methanolic KOH solution is usually the titrant. In this example, methanol is the solvent and KOH is the solute.
You need 1,5 g sugar for 50 mL water.
saturated
This is because the two substances are miscible, therefore once you get to a 50:50 mix the percentage of one must fall. The water then becomes a solute in the solvent alcohol in the case of your question.
Ethanol........this can be extracted by the process of fractional distillation. Hope that helps :)
Sodium chloride is the solute and water is the solvent.
No, it is undiluted from the bottle. In a vehicle it is mixed 50/50 with water (preferable distilled)No, it is undiluted from the bottle. In a vehicle it is mixed 50/50 with water (preferable distilled)
The solute is iodine. The solvent is a mixture of alcohol and water. There is no single fixed ratio for the mixture of alcohol and water but it usually is around a 50/50 mixture of water and alcohol with the iodine ranging from about 2% to 7% in concentration.
A good quality anti-freeze mixed 50/50 ratio with water A good quality anti-freeze mixed 50/50 ratio with water
Heating creates more spaces between molecules of the solvent like water. So, as the space between molecules increases, the sugar particles get into them faster. Thus the rate of dissolving increases
Standard green, mixed 50/50 with water.
Coolant container will say if it is pre-mixed or full strength. If full strenght, mix it 50/50 with water. Pre-mixed coolant can be added "as-is"
The solvent is usually the larger part of the solution which dissolves the solute. The solute is the smaller part which gets dissolved. So as an example, seawater is a solution. The solvent is water and the solute is salt and traces of other minerals. Vinegar is also a solution. Again, water is the solvent and glacial acetic acid is the solute. To do acid values in resin chemistry, methanolic KOH solution is usually the titrant. In this example, methanol is the solvent and KOH is the solute.
6.1 quarts mixed 50/50 water and antifreeze
It accelerates the germination of the seeds with a 10-50 percent sugar water to tap water concentration. Take 20 g of sugar and mix it into 200 ml of tap water, and add 50% OF THE SOLUTION to the seeds water suply, and the other 50% is tap water. If you do more than that it will kill the seeds.
mass is conserved (total mass is the sum of the mass of the constituents) so 50 + 50 = 100g