0
If ARPreply-only is configured on an interface what will this interface do?
Wiki User
∙ 10y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is difference between serial interface and Ethernet interface?
The FastEthernet interface of R1 is disabled. One of the default routes is configured incorrectly. A routing protocol is not configured on both routers. The default gateway has not been configured on both routers.
What interface is an interface that uses graphics as compared to a command-driven interface?
Graphical User Interface
Is Iterator a class or Interface?
Its an interface.
Can interface implement the other interface?
No. An interface cannot implement another interface, it can only just extend it. Because, an interface cannot implement any method as it has no method body declarations.
What interface is extended by AWT event listeners?
The AWTEventListener interface implements the EventListener interface.
What is difference between serial interface and Ethernet interface?
The FastEthernet interface of R1 is disabled. One of the default routes is configured incorrectly. A routing protocol is not configured on both routers. The default gateway has not been configured on both routers.
Line protocol in down then what you do?
there may be the issue with the layer 2 protocol like hdlc or ppp is not configured or wrongly configured if the interface is serial interface.
When must a router serial interface be configured with the clock rate command?
When the interface is functioning as a DCE device
What is the result of using the clock rate 56000 command at the serial interface of the router?
The interface is configured as a DCE device.
How many IP address can one Network Interface be configured with?
2
What is the reason for configuring a passive interface on a router?
To allow the subnet configured on that interface to be advertised through a dynamic routing protocol without having that interface participate in the protocol.
Which VLANs will be allowed across the trunk if SW-T has been configured with a single trunking interface?
All configured VLANs will be allowed across the trunk.
Which protocol family must be configured on an interface to allow ICMP traffic to be received?
inet
What command allows os To step up network interface and allow user to view information about the configured network interface in linux?
ifconfig
What is the purpose of the ip bandwidth percent eigrp 50 10 command?
This means eigrp with AS 50 has been configured to use 10 % of the configured bandwidth on the interface.
The PC the routing table of which is displayed is configured correctly To which network device or interface does the IP address 192.168.1.254 belong?
router interface fa0/0
What step must be completed before port security can be enabled on an interface?
The violation mode must be configured.
