Because, while the engine as a whole may be bad, there will be some part of the engine that could be repaired or replaced to make the engine work again.
Once the contribution margin is determined, it can be used to calculate the break-even point in volume of units or in total sales dollars.
The purpose of the break even equation, simply stated, is the determine the number of units a company must sell in order to brea-even (get out of debt). After you have determined the number of units, you then know where you will make a profit.
bhp or break horse power is determined by P=(TxRPM)/5252 Where P is break horse power T is Torque RPM is the engine speed and 5252 is a constant found from 33000/2pi As you can see power increases with engine speed, this is why you need a high revving engine to create lots of power.
VB does not determine that at all. Programmer can give loop break instructions. Break command will break loops programatically.
Engine crankshafts usually break when there is too much pressure on them. Some have flaws and may break under normal use.
Yes, they can break or just wear out.
The best article I've read on the web concerning 4-stroke engine break in, can be found here: http://www.mototuneusa.com/break_in_secrets.htm--Rayengine break in is very important, proper break in will help ensure long engine life.
because they live there life under the rule and regulation and break them.
Joshua Andrews invented the make and break engine in 1726. he invented it to power a snowmobiel called a Yamaha bravo. its a 5.3L v8 256hp engine.
when you want to break it
A prooblem in the engine of a crash
about 1000 for them to set. But for full break in about 2500