answersLogoWhite

0


Best Answer

master if the ide cable has a single drive connection. if the ide cable has the master and slave connection. then set the drive to master with slave.

User Avatar

Wiki User

6y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: If a single hard disk is attached on a primary IDE channel what should the jumper be set to?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What should the primary jumper be set to On a primary IDE channel if a single hard disk is attached?

master if the ide cable has a single drive connection. if the ide cable has the master and slave connection. then set the drive to master with slave.


What should be attached to the primary Y port in an IV set up?

Piggyback IV should be attached there.


Is the jumper good for all ages?

No. you should be off the jumper by 10 years old.


A jumper wire should be used to bridge the electrical ground across?

A jumper wire should use to bridge electrical ground across?


What can you do to stop the shoulders on your jumper stop sticking up too much?

Get a new jumper, that should not happen!


What is the name process if the jumper dried?

You should leave the jumper out to dry for about 5-10 mins


What should you wear if you are cold at home?

A jumper.


What are the benefits of using a baby jumper?

There are actually very few benefits of using a baby jumper. A jumper will allow a young child to get exercise and strengthen the legs and the neck but a child should not be in the jumper for more than 10 to 15 minutes.


If I like the jumper where should I pay for it?

While you are out shopping if you see the jumper that you like you should pay for it at the checkout. Most retailers accept cash, check or credit/debit cards.


Will a computer booted that has no jumper on the hard drive?

This question is highly dependent on the specifics of your hard drive. Some hard drives have jumper set ups where theres a setting that has no jumper. If that's your type of hard drive then there should be no issue. Either way the computer should boot regardless of jumper setup. It just may not be able to load the Operating System.


Should you say Attached are the reports or Attached is the reports?

attached are the reports


How many sizes larger should you get for a jumper that you want to be oversized?

You should get it one size larger.