== == That would be a 372. It should produce more torque at a lower rpm than the 350. Some machining required.
Answer If you do all the mod's, you get a 350 stroker---thats a 383 now.
130 at crank
a Chevy 350 crank is a Chevy 305 crank. they have the same stroke, 3.48 inches, and are interchangable. swapping between the two cranks does not change the engines displacement
The stroke of a crankshaft is determined by the way it is ground at the factory. You can't make a 3.75 stroke from a stock crank. If you bought a 3.75 stroke crank and put it into a 60 over 350 block, you'd have a 388. Rod length does not effect the size of an engine.
There's a clip holding it on. It's between the door panel and the crank. You have to use a flathead screwdriver and slip it between the door panel and crank to push it off. Try to push the panel in towards the door so you can see it.
No, it will crank, but it will not start.
is when sound going up wave is going down
Using the stock market requires knowledge on marketing and a lot of luck. You can review your stocks and when you see it going down you can pull it out. Remember that sometimes when the stock is down it doesn't mean it is not going to go back up.
crank up the phone and call
A faulty crank sensor would make the engine not run.
its still going on in the world.......BUT YOU CAN HELP MAKE A DIFFERENCE!
The year make a difference but in general the ecu fires the coil according to other signals like the crank sensor
is when sound going up wave is going down