0
If the clutch goes out 9 days after you buy a car does the dealer have to pay to have it fixed?
Wiki User
∙ 17y ago
I'm assuming it was a used car. If you bought it under "As Is" conditions the dealer does not have to pay. Check your sales contract.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
How to install a clutch in kx85?
I have the clutches in my kx 85 but the clutch rode that goes to the clutch cable keeps Hitting the clutch Case How do I fix it
What does a center plate do?
it goes in middle of clutch
My clutch pedals goes to floor and can't shift gears is my clutch bad?
Sounds more like a clutch slave cylinder.
Where goes the clutch master cylinder?
Usually on the firewall, driver's side, opposite the clutch itself.
How do you clutch wheelie?
its easy u just rev the engine as high as it goes and pop the clutch
What happens if the clutch goes out on my 1990 Jeep Wrangler while I am driving 65mph on the freeway?
This depends on what you mean by "goes out". If the clutch doesn't grab anymore you will cost to a stop. If the clutch will not release, you will have a hard time stopping.
How do tell if your clutch went out in a Ford F-350?
start it and try to put it in gear without using the clutch if it goes the clutch is shot
How do you know when the clutch goes?
When you engage the clutch and the engine sits there spinning: it get's no traction OR when there is no pressure on the clutch pedal: pressing it changes nothing.
What happens when your clutch goes out?
When your clutch goes out your rpms will climb up, but you will get no power. essentially your engine is in neutral, and therefore not transferring any power from your engine to your transmission.
What kind of oil goes in a 1983 Honda shadow?
I use 10 W 40 motor oil which I found in Canadian Tire - it is made specially for liquid clutch use, you can also buy it from a Honda dealer.
What would cause a slight nosie near clutch area and goes away when you pull on the clutch lever kx125 kawasaki?
Slack in the clutch release or clutch basket. It might adjust out.
How AC compressor clutch bearing?
The clutch bearing for an AC compressor is located in the center of the clutch. If the bearing goes bad, then the clutch is replaced as a whole part rather than changing the bearing.
