Since power is current times voltage, doubling current while keeping voltage the same will double the power. Ignoring slight non-linearity, if the power doubles, the heat will double.
we have to increase the winidin count of Coils inside the Alternator and also the Carbon mesh brush is to be increased so that the higher electric output will be produced................
The strength of the magnetic field inside the coil increases.
The flow in a circuit is called the electric current and it is measured by voltages. The number of volts that are present in the charge will determine the strength of the electric current.
You know if current is flowing in a bulb circuit because, if there is enough power (voltage times current), the bulb will illuminate. If there is current, but not enough power to illuminate the bulb, you will need to measure the current with an ammeter to see if there is any current.
The current flowing through a transformer's secondary is the current drawn by the load, so it will be exactly the same as the current flowing through your induction motor -assuming that is the load. Don't really understand the point of your question!
Flowing electricity is called electric current.
we have to increase the winidin count of Coils inside the Alternator and also the Carbon mesh brush is to be increased so that the higher electric output will be produced................
It depends on1 the resistance of wire.2the voltage between the ends of the wire.3the flowing current time.
Several things happened to the electrodes as a result of the electric current flowing. The electrodes conduct the electrical current and makes the circuit complete.
You can measure current - or the lack of current - with an ammeter.
A break in the wires of an electric current will break or cut the circuit and stop the current from flowing.
When the circuit is interrupted, the current stops flowing.
An electric current flowing through a circuit causes a magnetic field. This is due to the movement of electric charges, usually electrons, in the circuit. The magnetic field produced is perpendicular to the direction of the current flow.
Then the current will stop flowing.
When excited by electric current flowing in it.
This is known as DC. Direct Current.
Electric fuse