Want this question answered?
thermal convection
Temperature lag is when the month/time of day when insolation is longest does not match up with when surface temperature is greatest. This is because it takes a while for the sunlight to pass through Earth's atmosphere.
Convection currents in the earth's mantle. Release of heat from earth's interior.
Thermal
'''Thermal pollution''' is the rise or fall in the temperature of a natural body of water caused by human influence. A common cause of thermal pollution is the use of water as a coolant by power plants and industrial manufacturers. When water used as a coolant is returned to the natural environment at a higher temperature the change in temperature impacts organisms by (a) decreasing oxygen supply, and (b) affecting ecosystem composition. Urban runoff--storm water discharged to surface waters from roads and parking lots--can also be a source of elevated water temperatures
No
An atmospheric tide is a collective name for the pressure waves in the atmosphere similar to the tides of the ocean produced by the gravitational influence of the moon and by thermal expansion and contraction.
mesosphere, stratosphere
thermal convection
Phase diagram are also known as thermal equilibrium diagram or a consistutional diagram 1. Different uses of phase diagram are 2. prediction of phase 3. amount of phase 4.composition of phase
thermal convection is the primary force that cause the sea floor to spread
Hydro electric ,thermal and nuclear energy
The theory of the heat transfer experiment is the transfer of thermal energy between molecules, due to a temperature gradient. The conclusion of the experiment is that thermal conductivity is much higher in metals and does not change within thickness.
Primary blast effect
oil supply boiler turbine generator transformer electric output
Because the Moon's gravity is so much weaker than Earth's.
Thermal paste (or colloquially termed thermal grease by certain technicians or mechanics) is a TIM (thermal interface material). It's primary purpose is to transfer heat away from the heat source (in the case of electronics, the chips themselves). However, applying too much to a computer chip may actually be bad instead (it will act as a insulator and retain heat) and will cause your device to overheat.