no
NO!!!!! Find a charger with the same voltage!! If not, you will fry your battery. The only electrical number you can go higher on is the milliwats.
A: A DC adapter is basically like a battery except it is conditioned from an AC source. To change over measure the voltage when fully operational then switch to battery that have the same voltage as the adapter. the only concern should be the power required
No, you should always match the voltage requirements. Not only will your battery not charge you could actually damage it.
yes it can, the replacement battery's voltage must not lower than the original battery
No. You need to use the exact battery charger for the battery specified by the manufacturer, in order to achieve the correct charge cutoff point. In particular NiCad and similar batteries detect full charge by detecting the knee point in voltage per unit time given a specific charge current. Using the wrong charger could result in overcharge which will damage the battery.
Because the original voltage of the battery weakens over time after using it for awhile making the voltage less then the original amount stated on the battery.
The number of cells in a battery determine the battery's voltage. Different types of batteries have different cell voltages. The cell voltage is dependant on the reactive metals used. A typical car battery will have six cells. Because a typical cell voltage has a source voltage of approximately 2.0 volts, this makes a car battery produce a voltage of 12 volts.
No, it will overcharge the battery and overtime destroy it.
yes, but you need an adapter that plugs into the cigarette lighter. attached to the adapter is a 9volt battery. plug that into the lighter before disconnecting the cables to the car battery. that adapter w/ the 9 volt battery attached to it will keep just enough voltage in the cars computer system to allow you to change the cars battery. w/o that adapter when you disconnect the old battery and reconnect the new battery the cars onboard computer system will default and blow several fuses. go to an auto parts store and rent the adapter for a few bucks.
No, the voltage of the replacement adapter must always be IDENTICAL to the original adapter and the current of the replacement adapter must be the same or larger than the original adapter.Trying to use a 9 Volt adapter to replace a 5 Volt adapter will almost certainly completely destroy the device the moment you plug it in.You did not say whether the adapters provided AC or DC or the polarity if DC. Either way both the replacement adapter and the original adapter must be IDENTICAL in this respect.
With caution - yes. The higher voltage shouldn't cause any harm to the phone - due to circuitry built into the phone to 'smooth out' the voltage from the original charger. However - don't leave it connected for long periods once it's charged. It will take less time to charge the battery (due to the higher voltage). I've used 'replacement' chargers with phones in the past without any problems.
You might need a different pump. If there's an AC->DC adapter that goes between the mains outlet and the pump itself, you could try just replacing that with a battery case delivering the proper voltage.