Fuel and Engines
Nissan Pathfinder

If you have a 1989 Nissan Pathfinder 4x4 3.0 V6 and would like to put in a 3.3 V6 is this possible?


Top Answer
User Avatar
Wiki User
2015-07-16 19:27:43
2015-07-16 19:27:43

Agree - lots of work for only 0.3L of displacement. Try these: iridium plgs from ngk (both help my mpg), get a better air intake, check and post to the npora boards for performance mods. What is your goal??


I disagree, unless you have no previous engine experience. The 3.3 is near the exact same block and you can swap everything from the 3.0 onto the 3.3 with minimal problems or modifications. It's been done by more than a few people. Search NPORA for more info. http://npora.ipbhost.com


Related Questions

you certainly can but the only engine that is made disesl that would fit that truck would be an Isuzu and you would have to modify some stuff on it

Anything is possible. It may however not be very probable without many skills and much cash. Chris

The rims match an 89 Nissan Pathfinder for sure.

Your best bet would be a wrecking yard...the dealer would be a little pricey I imagine.

it is 12 atdc for the 88, I assume they are the same

I have owned several Nissan trucks since 1989 and the ECM has always been under the passenger's seat. This keeps the unit out of the extreme heat/cold and dampness under normal driving conditions. I just reprogramend my keyless entry on my 1995 pathfinder, the module was located under the driveride seat

You can use parts off a 1987-1995 Nissan pathfinder. 2 or 4 door will work just fine. Rule of thumb, a 2 door pathfinder is based on a regular cab pickup chassis, a 4 door pathfinder is based on a king cab chassis.

i was wondering if my Nissan maxima has a filter i can change myself 1989 model


How to Set timing on nissan sentra 1600cc 1989 model

This info. is good for 1989-1995 pathfinder. It holds 3.8 Liters of oil and 6 Liters of Transmission fluid. If you need more details check out: http://www.nissanextendedwarranty.com/owners-manual/nissan_owner_manuals.HTML It has lots of Nissan owners manuals.

Nissan Figaro was created in 1989.

Nissan Pao was created in 1989.

The 1989 Honda Prelude had 4x100mm offset. The 1989 Nissan 240sx has a 4x114.3mm offset...so, it will not fit.

Yes but why would you want to? The KA24DE is superior to the Z24 in many ways

In the fuel tank - under the back seat

Where i can find the fuse box diagram for a 1989 nissan maxima

Answering "Where is a oil pump locatedon a 1989 Nissan path finder?"

The Clutch slave cylinder is located on the passenger side of the bellhousing.I recommend to replace the Clutch Master cylinder also;if either one is replaced , the other will fail in no time.

The Nissan 240SX was brought to America in 1989.

It is important to have a diagram when messing with any wiring of a vehicle. A person can get a free wiring diagram from most car part stores, many times the technicians will make a free print out.

marica sea esta piazo e pagina q no ayuda un coño jodanc = q yo! I think there was a 1989 one, not a 1987, but I am not sure. There could have been 1987. PS this is not a translation of above answer.

Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.