answersLogoWhite

0


Best Answer

I WOULD BY A REFERENCE BOOK COVERING YOUR CAR IN AN PARTS STORE SHOULD BE VERY HELPFUL AND REMOVING THE PANEL SHOULD NOT BE DIFFICULT

Tonight I took off my door panel to get to the non-functioning window regulator and I thought it was a bit crazy what I had to do to get the thing off myself. First of all, there should be three (3) visible screws that need to be removed. One is in the top left corner of the panel, the other is down on the left corner of the panel inside the door pocket, and the other is down on the right corner of the panel. Next, you need to use a flat-head screw driver and remove the casing around the door handle. Then you need to pop up the casing around the power switches and with a Phillips screw-driver remove the 4 screws from the underside of the switches. Next, pop out the clear light covering on the bottom right corner of the door. You'll also need to twist out the bulb unit from the door. Then there are two hidden screws underneath either end of the door handle. Using a flat-head screw-driver, pop up the soft ends of the handle and you'll find your 2 screws. Lastly, carefully lift up on the panel to clear the hooks that are holding it in place and pop out the edges of the door so that it'll come right off. Good Luck!

The two screws are actually underneath the door pull handle, not the actual open latch where you would remove the rectangular like casing.

User Avatar

Wiki User

โˆ™ 2015-07-16 18:05:39
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: If you have a 1994 Mercury Marquis and how do you get the front passenger door panel off to fix the window?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the starter solenoid on the 1989 Mercury Grand Marquis?

its on the passenger side front near the front tire


Where is number two cylinder on a Mercury Marquis 4.6 liter?

Passenger side second cylinder from the front.


Does the 1997 grand marquis ls have dual air bags?

On a 1997 Mercury Grand Marquis : Yes , there are front air bags for the driver and front passenger ( SRS / Supplemental Restraint System )


Can you replace your front passenger window motor with the passenger rear window motor?

Yes


Does the mercury grand marquis have a bench seat in front?

Yes!


What are the clyinder locations on a 1999 mercury grand marquis?

Driver's side front to rear 1-2-3-4 Passenger's side front to rear 5-6-7-8


Where is the starter solenoid located on a mercury grand marquis?

The starter solenoid is located (in a 1989 mercury grand marquis), as you raise the hood, on the left hand side of the engine compartment. Just behind the battery. (you should be standing right in front of the passenger side headlight.)


How do you change front shocks on 1993 mercury grand marquis?

The 1993 Mercury Grand Marquis does not have front shocks. The Mercury has front struts. Compress the strut spring with a spring compressor. Remove the strut retaining bolts. Reverse the process to install the new front struts.


How Do you replace the front sway bar link in mercury grand marquis?

how do you replace the front sway bar likn in a 1999 Grand Marquis?


How do you remove the passenger side door panel on a 1998 Grand Marquis?

See the link below (steps 1-7)... http://www.autoclinix.com/Mercury/Front%20Speakers2.htm


Where is cylinder 6 on a 2003 Mercury grand marquis?

firewall 4 - 8 3 - 7 2 - 6 1 - 5 front of Mercury Grand Marquis


Are the driver front and passenger front window regulators interchangeable on a 1996 cirrus?

no

People also asked