the answer is 210 pounds-inches.
the answer is 50 pounds.
95 ft inches of torque , make sure it is in ft inches of torque and not ft lbs.
M1 = M2 x L1 / L2M1 is the torque setting of the wrench.M2 is the actual torque applied to the nutL1 is the normal length of the wrenchL2 is the extended length of the wrench (Length of wrench + length of adapter)Remember... Torque = Force x Radius
The pendulum frequency is dependent upon the length of the pendulum. The torque is the turning force of the pendulum.
A torque multiplier increases the torque by increasing the length from which a bolt or nut is turned. This process is referred to as "mechanical advantage."
torque = force * lever length torque = 15 * 55 torque = 825 n-cms
Yes, it is possible for a smaller force to have a large torque because it is usually located at a much greater distance from the center of rotation. Torque is calculated by multiplying the distance by the force.
for a given lever length the force is (150 / 100) times greater torque = force (pounds) * lever length (feet)
Torque= length x force. Lenght is the distance to an object. Force must be perpendicularly acting on the object. In your question, you did not specify neither force and length of the knob. So I cannot give you a torque value. I believe the SI unit for torque is "Nm", assuming that you calculated your torque using all SI units. Then you have to convert Nm to pounds.
It sort of depends on the muscle and the length of the "lever".
Breakaway torque is the torque required to start the initial movement, in the loosening direction, of a bolt, screw, or nut from its (non−loaded) at rest position with the locking element engaged. Tightening torque is the torque necessary to move the bolt, screw, or nut along its threaded length in the tightening direction.
Every Volkswagen owner needs John Muir's "How to Keep Your Volkswagen Alive." In it you will find the head torque on upright engines is 25 lb-ft--torque to 7 lb-ft and rest for 20 minutes, torque to 12 lb-ft and rest for 20 minutes, torque to 25 lb-ft and rest for 30 minutes, then recheck the torque one last time. And remember, always torque head nuts in a criss-cross pattern. I would suggest buying a Haynes manual for your bug. it should have the specs for it. (you can find them at Autozone) The official service manual is by Robert Bentley and is far superior to Haynes.