You can just extend the waste line from wherever it is currently to where the new drain point begins, its much easier connecting into an existing line than to try create a new one.
Why not check your local codes? Normally A trap should be located no more then 2 feet from the fixture being served and the vent no more then 2 ft from the trap thus you have 4 feet to play with CHECK LOCAL CODES
This would not be a good idea because if you get any back draft which is likely when the vent isn't working then you have one smelly bathroom.
NO
connecting hose drain to lg dehumidifier
Just forward and outboard from the oil filter, screws in horizontally.
With a level
By your question I assume you are using an electric dehumidifier to take air laiden moisture from your property. You do not say wha type of property you own but I would recommend you search for SOLARVENTI as a much cheaper answer to your problem
90How do I drain petrol from my transit connect
The toilet is 3 or 4 inch and the shower is 1 1/2 or 2 inch. You could reduce the toilet to 2 inch, but it would never flush correctly or be of much use. The current toilet drain has no trap in that section because one isn't needed. The toilet itself is the trap. If you are using existing waste lines, they should already be connected to the vent stack. If you are adding lines, connecting to the existing stack is fine as long as it is above the last drain.
Cut into the existing drain where you feel it would help the most and run a vet to the outside, preferably to above the roof line. At the point furthest from the main drain.
yes , i can connect the DeLonghi 40 Pint Electronic Control Dehumidifier to a hose and drain it outside
To connect a washing machine drain hose to a flexible hose it is proper to seal the union with plumbers tape and a hose clamp. Silicone should not be used because it may come loose and get into the drainage system. If Silicone is used it might also be necessary to cut the hose when removing the washer drain hose.